POWDPG80460 EN
Copyright © 2021 VARO P a g e | 11 www.varo.com
12.2 Lock-on (Fig.7)
▪ The lock-on feature is convenient when spraying for an extended period of time or when
covering a large area.
▪ To lock-on, press the trigger (12) and slide the lock on switch (17) forward.
▪ To release the lock-on, press the trigger (12) and slide the lock on switch backward (17) ,
release the trigger (12).
▪ NOTE: make sure the trigger is not locked on before inserting the battery pack into the
sprayer.
12.3 Filling the tank
▪ Liquids to be sprayed must be as thin as water. Thicker liquids will not spray properly.
▪ Do not overfill the tank.
▪ Remove the battery pack (18).
▪ Remove the lid (4). Fill the tank with the desired amount of water.
▪ Measure the recommended amount of liquid.
▪ Carefully pour the liquid into the tank.
▪ Reinstall the lid (4) and make sure it is fixed securely.
▪ Reinstall the battery pack (18).
▪ Spray solutions may be premixed and poured into the sprayer, using a funnel if needed.
▪ NOTE: be sure to thoroughly clean and rinse the measuring cup or funnel after use. If
premixing the spray solution, rinse the container used for mixing.
NOTE: It is important to thorougly clean the unit after each use. Allowing
liquid to remain in an idle tool for an extended period may cause its moving
pieces and connectors to seize up.
12.4 Spraying home and garden chemicals
▪ Install the battery pack (18) into the tool.
▪ Depress the ON/OFF button (16) to start the motor.
▪ Aim the sprayer nozzle directly at the plants or objects you wish to spray.
▪ NOTE: Make sure to stand far enough from the object being sprayed to prevent the spray
from splashing back onto you.
▪ Depress the trigger (12) to start the spray. Release the trigger (12) to stop the spray.
▪ Always empty, clean, and drain the tank after every use as directed in the Maintenance
section.
▪ Thoroughly clean the chemical sprayer before storing or before switching to a different
chemical. See Cleaning the Unit later in this manual.
▪ When you are finished with the sprayer, thoroughly wash your hands and any area where
skin has been exposed to the spray.
13 CLEANING AND MAINTENANCE
13.1 Cleaning
13.1.1 Draining the tank
▪ If there is any liquid left in the tank after spraying, the tank should be drained before
cleaning.
▪ Remove the battery pack (18).
▪ Remove the lid (4).
▪ Drain the contents through the fill area.
▪ NOTE: Drain the contents back into the original container. Do not store chemicals in the
tank.
