POWDPG80460 EN
Copyright © 2021 VARO P a g e | 9 www.varo.com
Note: if the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
1. Frequently monitor the charger and battery pack while connected
2. Unplug the charger and disconnect it from the battery pack when finished.
3. Allow the battery pack to cool completely before using it.
4. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool
down to room temperature before charging. This will extend the life of your
batteries.
9.2 Removal / insertion of battery (Fig. 2)
WARNING: Before making any adjustments ensure the hedge trimmer is
switched off or remove the battery pack.
▪ Hold the tool with one hand and the battery pack (18) with the other.
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
9.3 Battery capacity indicator (Fig. 3)
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button. Before using the machine, please press switch trigger to
check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are lit: Battery fully charged
2 LED’s are lit: Battery 60% charged
1 LED is lit: Battery almost discharged
10 BEFORE USE
10.1 Mixing the spray solution
▪ Never spray liquid plant control chemicals undiluted.
▪ Prepare solution and fill the container outdoors only or in well-ventilated locations.
▪ Only prepare sufficient solution for the job in hand so that nothing is left over.
▪ Do not mix different chemicals unless such a mixture is approved by the manufacturer.
10.2 Filling the container
▪ Stand the sprayer on a level surface, do not fill the container above the maximum mark.
▪ When filling from central water supply, do not immerse the end of the hose in the solution,
sudden low pressure in the system may cause the solution to be sucked back into the
water supply.
▪ Before filling the container with spray solution, carry out test run with fresh water and
check all parts of the sprayer for leaks.
▪ After filling, fit the lid and tighten it firmly.
▪ Hang a tag to the product to note what chemical is being used.
10.3 Application
▪ Work only in the open or in very well ventilated locations, e.g. open greenhouses.
