680440
35
Verklein
Vergroot
Pagina terug
1/144
Pagina verder
5.4 DIL switch5 / DIL switch6
SE2 safety device (closing):
See Figure9.7
The functions of the SE2 are set with DIL switch5 in
combination with DIL switch6.
5 ON Activation kit for closing edge safety device or
photocell with testing
5 OFF
• 8k2 resistance contact strip
• Photocell from another manufacturer
• No safety device (8k2 resistance between
terminals20 / 73, delivery status)
6 ON Brief, immediate reversing in the OPEN direction
(for SKS)
6 OFF
Brief, delayed reversing in the OPEN direction
(forphotocell)
5.5 DIL switch7
SE3 protective device (closing):
See Figure9.8
Delayed reversing to OPEN end-of-travel position.
7 ON Dynamic 2-wire photocell
7 OFF
• Static photocell without testing
• No safety device (wire jumper between
terminals20 / 71, delivery status)
5.6 DIL switch8 / DIL switch9
The functions of the operator (automatic timed closing / pre-
warning phase) and the function of the option relay are set
with DIL switch8 in combination with DIL switch9.
See Figure9.9a
8 ON 9 ON Operator
Automatic timed closing, pre-warning
phase for each gate movement
Option relay
Relay clocks rapidly during the pre-
warning phase, normally during the travel
phase and is OFF during the hold-open
phase.
See Figure9.9b
8 OFF 9 ON Operator
Automatic timed closing, pre-warning
time only for automatic timed closing
Option relay
Relay clocks rapidly during the pre-
warning phase, normally during the travel
phase and is OFF during the hold-open
phase.
See Figure9.9c
8 ON 9 OFF Operator
Pre-warning phase for each gate
movement without automatic timed
closing
Option relay
Relay clocks rapidly during the pre-
warning phase, normally during the travel
phase.
See Figure9.9d
8 OFF 9 OFF Operator
No special function
Option relay
Relay picks up in the CLOSE end-of-
travel position.
NOTE:
Automatic timed closing is only possible from the determined
end-of-travel positions (full or partial opening). Automatic
timed closing is deactivated if it fails three times. The operator
must be restarted with an impulse.
5.7 DIL switch10
Effect of the SE3 protective device as a through-traffic
photocell with automatic timed closing
See Figure9.10
10 ON The photocell is activated as a through-traffic
photocell, after the photocell has been passed,
the hold-open phase is reduced.
10 OFF
The photocell is not activated as a through-traffic
photocell. If, however, automatic timed closing is
activated and the photocell interrupted after the
hold-open phase has elapsed, the hold-open
phase will be reset to the preset time.
5.8 DIL switch11
Setting the reversal limits:
See Figure9.4 and section4.5
11 ON Reversal limit set step-by-step
11 OFF
Normal mode
5.9 DIL switch12
Starting point for slow speed when opening and closing:
See Figure9.3 and section4.4
12 ON Starting points are set for slow speed when
opening and closing
12 OFF
Normal mode
5.10 DIL switch13
Setting the hold-open phase:
See Figure9.5 and section4.6
13 ON Hold-open phase is set in increments
13 OFF
Normal mode
C300 - C800 / Rev. 1.1 RE / 07.2014 35
ENGLISH
35

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Berner C500 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Berner C500 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Spaans als bijlage per email.

De handleiding is 12,56 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info