680440
37
Verklein
Vergroot
Pagina terug
1/144
Pagina verder
6.2 Radio Remote Control
6.2.1 External radio receiver
Plug-in the external radio receiver on the respective
connector (see Figure 6.1). The function “impulse” (Open –
Stop – Close – Stop) and the function “partial opening” for at
max. 60 different hand transmitters can be programmed on
the external radio receiver. If more than 60 different hand
transmitters are programmed the receiver deletes those that
have been registred in the beginning.
6.3 Programming the hand transmitter buttons on
an external radio receiver
6.3.1 Assigning a button function for channel 1
1. Briefly press the P button (programming button) on the
receiver. The LED will begin to light up.
2. Press the desired button on the hand transmitter for at
least three seconds until the LED goes out.
3. Release the button.
4. The receiver is ready to receive.
The function of this hand transmitter button is now
programmed on the receiver (see Figure 11a).
6.3.2 Assigning a button function for channel 2
1. Briefly press the P button (programming button) on the
receiver. The LED will begin to light up.
2. Press the P button again. The LED will go out and then
light up again.
3. Press the desired button on the hand transmitter for at
least three seconds until the LED goes out.
4. Release the button.
5. The receiver is ready to receive.
The function of this hand transmitter button is now
programmed on the receiver (see Figure 11b).
6.4 Operation
At least one hand transmitter button must be taught in on the
radio receiver to operate the sliding gate operator via radio.
During radio transmission, the hand transmitter and receiver
must be at least 1 m apart.
6.5 Deleting all data of an external radio receiver
1. Press the P button on the receiver for
approx.10seconds. The LED will flash.
2. Wait until the flashing stops, and release the button.
Alltaught-in hand transmitters are now deleted.
NOTE:
It is not possible to delete individual hand transmitters.
7 Final Work
Replace the transparent cover (see Figure12) and close
the housing cover after completing all of the steps
required for initial start-up.
7.1 Fixing the warning sign
See Figure13
Fix the sign warning about getting trapped in a
noticeable, cleaned and degreased place, for example,
near to the permanently installed button for moving the
operator.
8 Operation
WARNING
Danger of injury during gate travel
If people or objects are in the area
around the gate while the gate is in
motion, this can lead to injuries or
damage.
Make sure that children are not
playing near the gate system.
Make sure that no persons or
objects are in the gate's travel
range.
If the gate system only has one
safety feature, only operate the
sliding gate operator if you are
within sight of the gate's travel
range.
Monitor the gate travel until the gate
has reached the end-of-travel
position.
Only drive or pass through remote-
control gate systems when the gate
is at a standstill!
WARNING
Danger of crushing and shearing
Fingers or limbs may be crushed and severed if caught in
the toothed track or between the gate and closing edge
while the gate is in motion.
Whenever the gate is moving, never touch the toothed
track, toothed wheel, and the main or secondary
closing edges.
8.1 Instructing users
All persons using the gate system must be shown how to
operate it properly and safely.
Demonstrate and test the mechanical release as well as
the safety return.
8.2 Function check
1. To check the safety reversal, stop
the gate with both hands while it is
closing.
The gate system must stop and
initiate the safety reversal.
2. Proceed in the same manner while
the gate is opening.
The gate system must stop and
reverse briefly.
In the event of a failure of the safety reversal, a specialist
must be commissioned immediately for the inspection
and repair work.
C300 - C800 / Rev. 1.1 RE / 07.2014 37
ENGLISH
37

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Berner C500 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Berner C500 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Spaans als bijlage per email.

De handleiding is 12,56 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info