EN
19
5
4
3
Do not use the appliance until the filter is perfectly dry. Use of a damp filter
could damage the appliance. As soon as stains or mould appear on the filters
surface, replace them with new ones, to be found at a Zepter Service Centre.
The life of this particular component is strongly influenced by how much the
appliance is actually being used.
AIR INTAKE FILTER
This prevents particles that have not been fully filtered by the SPRAY SYSTEM
TM
and the floater filter from reaching the motor. Check the efficiency of filter
when you are cleaning the purification tank.
To do this, remove and rinse repeatedly the filter, separating it from the
cover and the machine body (Pict.3) with the help of a small pliers (eyebrow
tweezers will do). Wash the filter element with plenty of cold water and neutral
detergent. Do not leave the filter to dry on heaters or radiators!
As soon as stains or mould appear on the filters surface, replace them with
new ones, to be found at a Zepter Service Centre. The life of this particular
component is strongly influenced by how much the appliance is actually
being used.
POLYESTER FILTER
In order to keep the filter always clean and ready for maximum performance, it
should be inspected monthly.
To inspect the filter, proceed in the following way:
1) Remove the exhuast filter cover, at the back of the TUTTOLUXO 6S (Pict. 4).
The polyester filter is fitted inside. Lay the exhuast
filter cover, on the floor and extract the filter as shown (Pict. 5).
2) Check the filter state; if there are traces of dust or dirt, wash with plenty of
warm water and neutral detergent to remove.
3) Allow the filter to dry naturally (not on radiators or heaters).
Do not use the appliance until the filter is perfectly dry. Use of a damp
filter could damage the appliance.
4) After cleaning, put the filter back into place and reassemble the cover,
making sure to properly fit the exhuast filter cover hooks
onto the slits on the appliance body. Once the filter cover is in place,
rotate it upwards for the final fixing with the stopping tongue.
After long periods of use, should the polyester filter be torn or damaged, it
should be replaced with a new one from the authorised Zepter Service Centres.
