EN
18
1
2
5
6
4. MOTOR INTAKE FILTER:
Designed to prevent various particles
(from carpets, dust or dirt present in
the air) from reaching the motor. It is
also used to filter the motor cooling air, a
unique function to be found only with all
TUTTOLUXO models (Pict. 5).
5. HEPA FILTER *optional
CODE: PWC-700-516
High Efficiency Particulate Air.
The HEPA filter technology assures
maximum efficiency of 99.97% particle
capture even smaller than 0.3 microns.
The HEPA filter also helps to eliminate
micro-organisms in indoor air. (Pict. 6).
9 - MAINTENANCE
After periods of intense use (check at least once every six months) it is necessary
to check the efficiency of all filtering elements. The appliance outer surfaces
can be cleaned with a cloth soaked in neutral detergent. Should the appliance
fall or overturn, switch off immediately and disconnect from the mains. If
the machine gets in contact with water, dry it with a dry cloth and wait a few
minutes before switching on again. Do not put away the appliance whilst the
tank still contains dirty water, as this may cause bad smells from mould and
encrustations forming inside the tank.
Do not direct jets of water or high pressure steam at the appliance (even
when disconnected from the mains) to clean it! Do not use high pressure
cleaning machines!
IMPORTANT! Before carrying out any type of maintenance, turn the
machine off and disconnect from the mains.
9.1 FILTERS
The following filters should be replaced immediately if you notice any
damage to them! Contact your Zepter Service Centre for new filters.
FLOATER FILTER
This filter traps the bigger dirt (e.g. leaves)
which is not kept by the rainstorm of
the Spray System
TM
and is therefore an
important gate-keeper and protector for
the next filter, the Air Intake Filter. (Pict. 3).
Check the efficiency of filter.
To do this, remove the filter with the
help of the float (Pict. 2), by pushing it up
against the filter. Wash the filter element
with plenty of cold water and neutral
detergent.
Do not leave the filter to dry on heaters
or radiators! Allow the filter to dry naturally
(not on radiators or heaters).
