44
Adjusting the BALANCE control
Adjust the balance of the output volume to the left and right
speakers to compensate for sound imbalance caused by
speaker location or listening room conditions.
Note
This control is effective only for the sound from the main
speakers.
Using the BASS EXTENSION switch
You can boost bass frequency response by setting this switch
to the “ON” position. This switch is effective only on the sound
from the main speakers.
Adjusting the BASS and TREBLE
controls
BASS : Turn this clockwise to increase (or counter-
clockwise to decrease) the low frequency
response.
TREBLE : Turn this clockwise to increase (or counter-
clockwise to decrease) the high frequency
response.
Note
These controls are effective only for the sound from the main
speakers.
Notes on recording
●
The settings of DSP and the VOLUME, BASS, TREBLE,
BALANCE controls and the BASS EXTENSION switch
have no effect on the material being recorded.
●
Composite video and S video signals pass independently
through this unit’s video circuits. Therefore, when recording or
dubbing video signals, if your video source unit is connected
to provide only a S video (or only a composite video) signal,
you can record only a S video (or only a composite video)
signal on your VCR.
●
A source that is connected to this unit between optical
digital terminals only cannot be recorded by a tape deck or
VCR other than the tape deck (or MD recorder etc.)
connected to the OPTICAL MD/TAPE 1 REC terminal of
this unit.
●
Dolby Digital (AC-3) RF audio input signal cannot be
recorded by a tape deck or VCR. To record an LD source,
the LD player must be connected to the OPTICAL digital
audio signal input terminal and/or analog audio signal input
terminals of this unit.
●
A source of signals input to the EXTERNAL DECODER
INPUT terminals of this unit cannot be recorded.
●
Please check the copyright laws in your country to record
from records, compact discs, radio, etc. Recording of
copyright material may infringe copyright laws.
If you watch a video software that uses scramble or
encoded signals to prevent it from being dubbed, there
may be a case that display information superimposed on
the picture and/or the picture itself is disturbed due to
those signals.
