809350
42
Verklein
Vergroot
Pagina terug
1/48
Pagina verder
42
Eliminate fault
Sense ll – 6 720 812 775 (2014/10)
Faults you can fix yourself
If an operating fault cannot be rectified:
Contact an authorised installer, or customer service.
Submit error code, additional code and control unit ID
number.
Fault
code
Sub-
code
Cause or fault
description Test procedure/Cause Corrective measure
Nothing appears on the display System is switched off. Switch on the system.
The power supply to the controller has been
interrupted.
Check that the controller is
correctly seated in its wall
bracket.
A01 810 DHW stays cold. Check if water is possibly being drawn from the
DHW cylinder constantly due to taps being open.
If water is being drawn
constantly, take action to stop
this.
A01 811 DHW heating: thermal
disinfection failed
Check if water is possibly being drawn from the
DHW cylinder constantly due to taps being open.
Take action to stop water being
drawn constantly.
A11 1010 No communication via
BUS connection EMS 2
Check that the controller is
correctly seated in its wall
bracket.
A11 1038 Invalid time/date Date/time not yet set Set date/time.
Prolonged loss of power supply Avoid voltage failures.
A11 3061
...
3064
No communication with
heating circuit module
(3061: heating
circuit 1, ..., 3064:
heating circuit 4)
Check that the controller is
correctly seated in its wall
bracket.
A11 6004 No communication w.
solar module
Check that the controller is
correctly seated in its wall
bracket.
A21
...
A24
1001 No BUS connection between Sense ll and Sense I
in the corresponding heating circuit (A21:
heating circuit 1, ..., A24: heating circuit 4).
Check that the controller is
correctly seated in its wall
bracket.
A41
A42
4051
4052
Thermal disinfection
failed.
Check if water is possibly being drawn from the
DHW cylinder constantly due to taps being open.
Take action to stop water being
drawn constantly.
H... Maintenance required. The system keeps
operating as far as possible.
Make arrangements to have the
system serviced by your
Servicing Engineer.
H07 1017 Water pressure in the system is too low. This
value is only displayed if your system is equipped
with a digital pressure sensor.
Top up the heating water as
described in the operating
instructions of the heat source.
Table 40
__ _
Table 41 The control unit ID number must be filled in here by the installer at installation.
42

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Worcester-Bosch Greenstar Sense ll bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Worcester-Bosch Greenstar Sense ll in de taal/talen: Engels als bijlage per email.

De handleiding is 4.46 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info