809350
40
Verklein
Vergroot
Pagina terug
1/48
Pagina verder
40
Eliminate fault
Sense ll – 6 720 812 775 (2014/10)
Problem Cause Remedy
Required room
temperature
not achieved.
Thermostatic valves
on the radiators are
set too low.
Set the thermostatic
valves higher.
Temperature for
heating mode is set
too low.
Set the temperature
for heating mode
higher.
System in summer
mode.
Switch system over
to winter mode
( Chapter 5.3.4,
page 25).
Flow temperature
controller on heat
source set too low.
Set the flow
temperature higher
( operating
instructions for the
heat source).
Air in the heating
system.
Bleed the radiators
and the heating
system.
Installation location
of the outdoor
temperature sensor
is not optimal.
Contact Installer to
install the outside
temperature sensor
at a suitable
installation location.
Required room
temperature
greatly
exceeded.
Radiators become
too hot.
Set thermostatic
valves in adjoining
rooms lower.
Set temperature for
the operating mode
concerned lower.
Set temperature for
all operating modes
lower.
If the controller is
installed in the
reference room, if
the installation
location of
controller is
unfavourable,
e.g. external wall,
close to window, in
a draught ...
Contact Installer to
install the controller
at a suitable
installation location.
Table 39 Eliminating "sensed" faults
Excessive room
temperature
fluctuations.
Temporary
influence of external
heat on the room,
e. g. from solar
exposure, room
lighting, TV,
fireplace etc.
Contact Installer to
install the controller
at a suitable
installation location.
Temperature
rises instead of
dropping.
Incorrect time set. Reset the time
Room
temperature
too high during
setback mode.
The building retains
a lot of heat.
Set an earlier
switching time for
setback mode.
DHW cylinder
does not heat
up.
DHW temperature1)
on heat source set
too low.
Set the DHW
temperature1)
higher.
DHW temperature1)
on heat source not
set too low.
Contact Installer to
check the settings on
the controller.
If the DHW system is
controlled via a
module: Flow
temperature1) on
heat source set too
low.
Set flow
temperature1)
higher.
DHW program
incorrectly set.
Set DHW program.
The DHW heating
configuration does
not suit this heating
system.
Contact Installer to
check the settings on
the controller.
The DHW at the
draw-off points
is not reaching
the required
temperature.
Mixer set lower than
the required DHW
temperature.
If you are in doubt,
contact your Installer
to come and check
the mixer setting.
0 is displayed
constantly in
the info menu
under solar
yield even
though the
solar system is
in operation.
Solar system set
incorrectly.
Contact Installer to
check the settings on
the controller.
1) See operating instructions of the heat source for further
information.
Problem Cause Remedy
Table 39 Eliminating "sensed" faults
40

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Worcester-Bosch Greenstar Sense ll bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Worcester-Bosch Greenstar Sense ll in de taal/talen: Engels als bijlage per email.

De handleiding is 4.46 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info