697434
38
Verklein
Vergroot
Pagina terug
1/72
Pagina verder
Commissioning
6720813171 (2016/05)38
Open the heating flow and return isolating valves on the pump group
(open position: parallel to the pipe).
Fig. 75 Opening the isolating valves (here: open position)
Read the pressure from the pressure gauge on the pump group or on
the control panel of the BC10.
The pressure in the heating system, which is measured directly at the
boiler, must be at least equal to the required pre-pressure of the
expansion vessel plus 0.5 bar. This minimum pressure must not be less
than 1.0 bar (if the heating system is cold). The maximum pressure in
the heating system, measured directly at the boiler, must not exceed
3.5 bar.
Fig. 76 Reading the pressure gauge
Purge the heating system via the air vents on the radiators. Start at
the lowest floor of the premises and then work your way up from floor
to floor.
Fig. 77 Purging the heating system
If the boiler has been in use for approximately one week and the pressure
reading on the display is less than 1.0 bar, the system has to be topped
up.
The pressure loss in a heating system is caused by air bubbles escaping
via fittings and (automatic) air vent units. The oxygen contained in the
fresh heating water will also escape from the heating water after some
time and cause the pressure in the heating system to drop.
This explains why it is normal that the heating system must be topped up
a couple of times after commissioning it. Eventually the system will have
to be topped up on average once a year.
Should it be necessary to top up the heating system more frequently,
water is probably escaping due to a leakage in the system or a defective
expansion vessel. In this case the cause of the water loss must be
repaired as soon as possible.
10.1.2 Filling the condensate trap with water
Fill the condensate trap with water.
Fig. 78 Filling the condensate trap with water
10.2 Testing and measuring
10.2.1 Checking for gas leaks
Prior to the initial start-up check that the gas supply pipework is gas-
tight; this must be confirmed in the commissioning log book.
6 720 648 726-075.1TD
P1
0
1
6 720 648 726-076.1TD
6 720 648 726-077.1TD
DANGER: Danger of fatal accident from explosive
fumes.
Pipes and fittings may leak after commissioning and
maintenance activities have been carried out.
Carry out a correct leakage test.
Only use approved leak detection spray to locate
leaks.
CAUTION: Damage to the installation due to short
circuits
Cover any hazardous locations prior to locating the
leaks.
Do not spray the leak detection product on cable
runs, plugs or electrical wiring. Do not let it drip onto
them either.
6 720 648 726-016.1TD
38

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Worcester-Bosch GB162-80 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Worcester-Bosch GB162-80 in de taal/talen: Engels als bijlage per email.

De handleiding is 5,43 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Worcester-Bosch GB162-80

Worcester-Bosch GB162-80 Installatiehandleiding - English - 12 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info