697434
36
Verklein
Vergroot
Pagina terug
1/72
Pagina verder
Operation
6720813171 (2016/05)36
Settings Menu
Step 1 [\/2/4| Display value. Currently measured CH flow temperature in °C. Also see section 14.2, page 53.
Step 2 Open the “Settings” menu? Yes: step 3
No: step 1
Step 3 To open the “Settings” menu: Press and hold the d + e buttons for more than 2 seconds
Step 4 [l/-/-] Display setting. As soon as the display shows [l/-/-], the “Settings” menu is open. You can set the boiler
performance using the first parameter shown on the display. Also see section 14.3, page 54.
Step 5 Adjust boiler performance? Yes: step 7
No: step 6
Step 6 Lower: Decrease the target boiler output with the c button. The minimum setting is [l/2/5] = 25 % with an 80-kW
boiler, [l/2/0] = 20 % with a 65 or 100-kW boiler and [l/3/0] = 30 % with a 50-kW boiler.
Higher: Increase the target boiler output with the d button. The maximum setting is [l/-/-] = 100 %.
This is equal to the factory setting.
Step 7 Press the e button.
Step 8 [f/\/5| Display setting: Set the second parameter as soon as the display shows [f/\/5|.
This parameter shows the target pump run-over time in minutes after heating operation has ended.
Also see section 14.3, page 54.
Note: Do not set a pump run-over time of less than [f/\/5| (= 5 minutes).
Step 9 Set the pump run-over time after heating operation has ended? Yes: step 10
No: step 11
Step 10 Lower: Decrease the target pump run-over time after the end of heating operation with the c button.
The minimum setting is [f/\/0| = 0 minutes. The factory default setting is 5 minutes.
Caution: Do not set the target pump run-over time after the end of heating operation to less than 5 minutes.
Higher: Increase the target pump run-over time after the end of heating operation with the d button.
The maximum setting is [f/6/0| = 60 minutes or [f/1/d| = 24 hours.
Step 11 Press the e button.
Step 12 [c/\/1| Display setting. Set the third parameter as soon as the display shows [c/\/1|. This parameter indicates
the DHW mode status setting. This enables DHW mode to be switched off or on. This setting has priority
over other DHW mode settings, such as those made on the room thermostat. Also see section 14.3,
page 54.
Step 13 Set the DHW mode status? Yes: step 14
No: step 15
Step 14 Set the DHW mode target status with the c or d buttons. [c/\/1| means “On”, [c/\/0| means “Off”.
Please note: Setting [c/\/0| also switches off the hot water cylinder frost protection.
Step 15 Have at least 5 seconds passed without a button being pressed and/or has the mains voltage been interrupted? Yes: step 17
No: step 16
Step 16 Press the e button.
Step 17 [\/2/4| Display value. Any adjustments that you have made have been confirmed. step 1
Table 13 Settings
36

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Worcester-Bosch GB162-80 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Worcester-Bosch GB162-80 in de taal/talen: Engels als bijlage per email.

De handleiding is 5,43 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Worcester-Bosch GB162-80

Worcester-Bosch GB162-80 Installatiehandleiding - English - 12 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info