783524
36
Verklein
Vergroot
Pagina terug
1/44
Pagina verder
32
16) Place a suitable container under the hot water wand. Open the hot water valve and turn the power switch to
Position I. Pump about 16 ounces of solution through the wand. Turn the Power Switch to Position 0 and then
close the hot water tap and unplug the machine.
17) At this point, the de-scaling agent has been pushed through all possible avenues where water can be passed.
Leave the machine off, unplug the power cord, and allow the machine to sit for a few hours. Refer to the instruc-
tions on the de-scaling agent’s container for a better idea of how long this should take. The amount of soaking
time is also a matter of the mineral content of your water, how much use your machine gets, and how long it
has been since the last de-scaling.
18) After the requisite time has passed, place a suitable vessel under the hot water tap, plug in the machine, open
the hot water valve, and turn the power switch to Position I. Pump about 8 ounces of solution through the wand.
Turn the Power Switch to position 0 and then close the hot water tap and unplug the machine. If the liquid you
drained looks quite fouled with scale, refill the reservoir with de-scaling agent by pumping another 16 ounces
of cleaner through the hot water wand (repeating the process starting back at step 15. Excessive scale in the
drained water indicates that you need to de-scale more often. If the water does not look very polluted with hard
water deposits that have been dissolved, continue with step 18.
18) Empty and thoroughly wash and rinse the water reservoir, fill it with the water you normally use in the ma-
chine, and replace the hose with the particle filter in the end back into the reservoir (if used, do not replace the
water softener yet).
19) Place the bypass hose in a suitable container. Removing this hose from the reservoir will keep the water in
the reservoir free from the de-scaler which is still in the pressure relief system.
20) Place a container under the grouphead, turn the power switch to Position I and immediately turn on the brew
cycle for fifteen seconds or more to flush out the grouphead and thermosyphon pipes. Turn off the brew cycle
and immediately turn the Power Switch to position 0.
21) Lock the Portafilter with the blind filter basket in place on the grouphead. Turn the Power Switch to Position
I and run the brew cycle for five or ten seconds after the brew pressure gauge reaches about 9 BAR to flush the
over pressure relief valve. Turn off the Brew Cycle and turn the Power Switch to Position 0.
22) Remove, rinse, and replace the blind portafilter.
Turn the Power Switch to Position I and t
urn the brew cycle
on and off a few times as when you are backflushing to clear the rest of the grouphead. Turn the brew cycle off
and turn the Power Switch to Position 0.
23) With the autofill wire still disconnected, place a suitable container under the steam wand and open the steam
valve. Turn the power switch to position “I” only. The autofill is defeated and so the machine will pump a stream
of water through the steam wand. Continue pumping until the water is clean and is free of descaling agent. Close
the valve and set the Power Switch to Position 0. Remember to check the reservoir level during this process.
24) Once again, place a suitable vessel under the hot water tap, open the hot water tap and turn the Power Switch
to Position I. Allow a stream of water to come from the steam wand until the water is clean and is free of des-
caling agent. Close the valve and set the Power Switch to Position 0.
25) Repeat steps 18 through 24 until the water you drain is tasteless (totally free from the taste of the cleaner).
This might take as many as three or more rinses.
CAUTION: Most proper de-scaling agents are a form of citric acid which is food grade, and in highly
diluted form is safe to consume. Sample only a very small amount (one drop on a clean fingertip) to be safe.
Thoroughly wash your hands in hot, soapy water before and after doing this test.
26) When the drain water is clean and free from the acidic taste of the cleaner, turn the power switch to “0” and
unplug the machine.
36

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Vibiemme Domobar Super bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Vibiemme Domobar Super in de taal/talen: Engels als bijlage per email.

De handleiding is 4.39 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info