23
How to Use
22
How to Use
3
Select gender
Select either the or key.
* On this screen the key has been selected.
The trunk fat % percentage display appears as .
(The moves as shown in the diagram at right)
*To change to gender selection, turn the unit off then on again before
making a new selection.
4
Commencing fat measurements
1.Wet the area of the abdomen to which the
electrodes are to be attached.
2.Place the impedance meter across the navel of
the subject.
* The impedance meter can be oriented in either
direction.
3.The impedance meter detects the subject’s body and a buzzer will sound (beep).
4.The buzzer will sound twice when measuring is completed (beep, beep).
5
Place the impedance meter directly under the main unit.
Data communication will commence.
For Your Reference
Infrared communication may not be possible when:
• the unit is set up outdoors or in direct sunlight
•clothing or other items come between the main unit and the impedance
meter
•lighting is positioned close by
•remote controllers for televisions, etc., are used near the impedance meter or
the main unit
•the batteries have expired
•the impedance meter is outside the infrared ray communication range (see
diagram at right)
*the communication distance is changed due to the effect of lighting appliances.
Please…
To wet, wipe lightly with moistened cotton
wool or a damp cloth.
Please…
Check that the green Power LED is on when positioning the impedance meter on the
subject.
*Once the impedance meter Power LED has come on, it will automatically switch off after approximately
10 minutes should the impedance meter not be placed on the abdomen.
Please…
Do not use two or more main units in conjunction as this could cause malfunctions.
6
Display of measuring results
The trunk fat % percentage and Visceral fat rating are
displayed (on the upper and lower bar, respectively).
* The main unit buzzer will sound twice when the display is
complete (beep, beep).
* Please refer to pages 32 and 33 for how to read results.
Position the meter so that this point
is roughly above the navel.
Measuring
waist circumferences over 130cm (cont’d)
Check that the Power
LED is illuminated.
