3130
MEMO - Wireless weather station
MEMO - Wireless weather station
7.3 Weather forecast
Sunny Slightly cloudy Cloudy Rainy Stormy
• The weather station has five different weather symbols (sunny, slightly cloudy, cloudy, rainy, stormy).
• The weather forecast covers a range of 12 hours and indicates only a general weather trend. For
example, if the current weather is cloudy and the rain symbol is displayed, it does not mean the
product is faulty because it is not raining. It simply means that the air pressure has dropped and the
weather is expected to get worse but not necessarily rainy. The accuracy is about 70 %.
• The sun symbol also appears on a starry night.
Note!
• Please note that the forecast symbol will become more defined in the course of operation. The fore-
cast symbol is active right from the start, however, the reliability of the forecasts increases with the
amount of data collected.
7.4 Temperature and humidity
7.4.1 Maximum and minimum values
• The highest and lowest indoor and outdoor temperature and humidity since the last reset are perma-
nently displayed.
• Press and hold the CLR/SNZ button for 2 seconds to reset the values.
7.1.4 Time zone setting
• In the setting mode you can make the time zone correction (+12/-12).
• The time zone correction is needed for countries where the DCF signal can be received but the time
zone is different from the DCF time (e.g. +1=one hour plus).
7.2 Alarm function
• Press the MODE button in normal mode, to enter the alarm mode.
• ALARM and 07:00 (default) or the last adjusted alarm time appear on the display.
• Press and hold the MODE button.
• The alarm symbol will appear and the hour digit will be flashing. The alarm is activated.
• Press the +/°C °F or -/RCC button to adjust the hours.
• Confirm the setting with the MODE button and set the minutes in the same way.
• Press the MODE button again.
• The current time and the alarm symbol appear on the display.
• When the adjusted alarm time is reached, the alarm will ring.
• The alarm symbol will be flashing.
• If the alarm is not stopped manually, the ascending alarm tone automatically turns off after two min-
utes and will be reactivated at the same set time.
• Press any button (except CLR/SNZ) and the alarm will stop.
• Press CLR/SNZ button to activate the snooze function.
• Once the snooze function is activated, Zz will be flashing on the display.
• The alarm will be interrupted for 10 minutes.
7.2.1 Activate/turn off alarm
• Press the +/°C °F or -/RCC button in alarm mode to activate or deactivate the alarm function.
• The alarm symbol appears/disappears.
TFA_No. 35.1141_Anleitung 24.06.2016 11:44 Uhr Seite 16
