19
Finalize Pre-Flash setting for non-SeaLife digital camer
as
Follow these steps to determine the correct Pre-Flash setting for
your non-SeaLife camera:
1. Set the pre-flash setting to #4.
2. Power on the camera and flash.
a. Make sure the camera settings are set as described in
section III of this manual.
b. Turn the flash brightness power knob on the back of the
flash to 9 or 10 position. (Not Auto position)
3. Wait for the red flash-ready light to turn on.
4. Take a test picture of an object about 3ft/1m shooting distance.
5. Review the picture on your camera.
6. Is the picture dark or very bright (possibly overexposed)?
a. If the picture is a dark picture, move the pre-flash setting
switch down by one (For example, from #4 to #3) and
repeat steps 3 to 6.
b. If the picture is bright (possibly overexposed) the pre-
flash setting is correct. You have now finalized your pre-
flash setting.
Note: Once you have determined the correct pre-flash setting for your
camera, you should not have to change it again. This will become
your permanent pre-flash setting unless you change cameras.
