20
Finalize Auto mode setting for non-SeaLife digital camer
as
Follow these steps to determine the correct Auto mode setting for
your camera:
1. Set the Auto mode setting to #4.
2. Power on the camera and flash.
a. Make sure the camera settings are set as described in
section III of this manual.
b. Turn the flash brightness power knob on the back of the
flash to the for Auto. (All the way counter-clockwise)
3. Wait for the red flash-ready light to turn on.
4. In a dimly lit room, take a test picture of a flat non-reflective object
(like a painting on the wall) at about 5ft/1.5m shooting distance.
5. Move the Auto mode setting switch down by one (For
example, from #4 to #3) and repeat steps 3 to 5 until you have
taken 4 pictures, one picture for each setting.
6. Review the pictures on your camera or computer and determine
which of the 4 pictures have the best color and exposure.
7. Set the Auto mode switch to the position which matches the best
picture taken in the above test. For example, if the second picture
is the best of all four pictures, set the Auto mode switch to #3.
8. You have now finalized the Auto mode setting.
Note: Once you have determined the correct Auto mode setting
for your camera, you should not have to change it again unless
you change cameras. Most SeaLife cameras will perform best in
the #1 position).
