www.scheppach.com service@scheppach.com +(49)-08223-4002-99 +(49)-08223-4002-58
24 I 108
Storage
1. Never store the equipment with petrol in the tank
inside a building where fumes can reach an open
ame or spark.
2. Allow the engine to cool before storing in any en-
closure.
3. To reduce the re hazard, keep the engine, silencer,
battery compartment and petrol storage area free
of vegetative material and excessive grease.
Long term storage/hibernation
1. In case of long term storage drain out the complet
fuel. Fuels are chemical compounds which change
their properties during prolonged storage. If the fuel
tank has to be drained out this should happen out-
doors.
m WARNING
Improper maintenance or ignoring/ not rectifying a prob-
lem during the operation may become a source of dan-
ger. Operate your machine only if regularly maintained.
Only in this way you can assume that your device is op-
erating safe, economical and without malfunctions.
Do not clean, maintain, setup or repair the machine
whilst running. Moving parts may cause serious in-
juries. Do not use fuel or other ammable solvents to
clean the equipment.
m WARNING
Vapours of fuels and solvents may explode.
Rex the security and safety equipment after reparation
and maintenance work.
Keep the machine in safe work condition. Especially
check the fuel system for tightness.
Always remove any dirt from the cooling ns of the en-
gine.
Residual risks and accident prevention
standards
Neglect of ergonomic principles
Negligent handling of personal protective equip-
ment
Negligent handling or ommission of the personal protec-
tive equipment may cause serious injuries.
– Wear prescribed personal protection equipment.
Human behaviour, misbehaviour
For any work be fully concentrated.
m Residual risks - Cannot be entirely excluded.
Specic safety instructions for handling the device
1. Thoroughly inspect the area to be worked, keep
the working area clean and free of debris to pre-
vent tripping. Operate on a at level ground.
2. Never place any part of your body where it would
be in danger if movement should occur during as-
sembly, installation, and operation, maintenance,
repairing or moving.
3. Keep all bystanders, children, and pets at least 23
meters (75 feet) away. If you are approached, stop
the unit immediately.
4. Do not mount on dump box and never carry pas-
sengers.
5. Never park the machine in a place with unstable
ground which could give way, particularly when it
is full.
6. Disengage clutch lever before starting the engine.
7. Start the engine carefully according to instructions
and with feet well away from the moving parts.
8. Never leave the operating position when the en-
gine is running.
9. Always hold the unit with both hands when operat-
ing. Keep a rm grip on the handlebars. Beware
that the machine may unexpectedly bounce up-
ward or jump forward if the machine should strike
buried obstacles such as large stones.
10. Walk, never run with the machine.
11. Do not overload the machine capacity. Drive at a
safe speed, adjusting the speed to the slope of the
land, the surface conditions of the road, and the
weight of the load.
12. Use extreme caution when in reverse or pulling the
machine towards you.
13. Exercise extreme caution when operating on or
crossing gravel drives, walks, or roads. Stay alert
for hidden hazards or trafc.
14. On soft ground, drive at the rst forward/reverse
gear. Do not rapidly accelerate, turn sharply or
stop.
Safety informations service/ mainte-
nance and storage
1. Only original parts may be used for maintenance
and accessories.
2. Replace faulty silencers.
3. Before using, always visually inspect to see that the
tools are not worn or damaged. Replace worn or
damaged elements and bolts. Keep all nuts, bolts
and screws tight to be sure the equipment is in safe
working condition.
4. Regularly check for leakage or traces of abrasion
in the fuel system, such as porous pipes, loose or
missing clamps and damage to the tank or tank
cap. Before use all defects must be repaired.
5. Before checking or adjusting the machine or the
motor, the ignition plug and the ignition wire re-
spectively must be removed to prevent acciden-
tal starting.
