1615
ADJUSTMENT OF CHAIR
MASSAGING (WHOLE BODY SENSOR AUTOMATIC COURSE)
Refer to the page 27 and 28 regarding the massaging contents of Whole Body Sensor Automatic Course.
Change of course during massaging, or change to the Automatic Course or the Manual Course, is possible.
When the button is pressed, the lamp of the remote control
illuminates and the sole warmer will turn on.
When the foot rest is fully lowered, the foot rest will rise a little.
When the massaging rollers are not located in the upper section,
the massaging rollers will move to the upper section and stop.
(During the movement, the characters of "ORIGIN" on the remote
control flicker.)
Sole warmer will be turned on or off each time the SOLE WARMER button is pressed.
(The button is illuminated while the sole warmer is on.)
If you feel that the sole warmer is too hot, turn it off by pressing the SOLE WARMER button.
8
Reclining is returned automatically
to the home position when
the HOME POSITION button
is pressed.
4
Press the desired Whole Body Sensor Automatic Course button.
5
Put the sensor controller on the arm rest
and place your fingers on the sensor.
Sensor
Sensor controller
Sensor lamp
Arm rest
1
Press the OPERATION ON/OFF button.
3
Adjust the positions of the back rest and the foot rest. (See page 13-15)
2
Turn the sole warmer on or off.
Foot rest
7
Adjustment of foot rest position (length).
If the knees or the calves do not fit the
foot rest, its position (length) can be
adjusted.
6
Adjust the angle of the foot rest.
Angle adjustment can be made for
foot rest only.
Adjustment range
Approx. 90
Foot rest
Extends when
pushed by the
soles
Shortens when
the feet are lifted
Foot rest slide lever
Pull toward
you
Back rest
Foot rest
Press
Firm massage by
shiatsu operation
STIFFNESS RELAX
Massage to relax
the whole body
RECOVERY
Tapping massage
to ease muscle
fatigue
FINE
Massage to
promote blood
circulation
Raise the foot rest by
continuously pressing the
UP ( ) button.
Lower the foot rest by
continuously pressing the
DOWN ( ) button.
Press
When the room temperature is low such as in winter, it takes some time to warm up or you
may barely feel warm.
Be sure to place your fingers on the sensor. The degree of stiffness cannot be measured if your fingers are
not placed on the sensor. (The sensor lamp will flicker and the characters of “Grip the sensor” on the
remote control will be illuminated.) In such a case, massages will be carried out according to the standard
operation of the selected course.
When the user’s skin is dry (especially a person with dry skin), the degree of stiffness may not be measured
correctly. In such a case, slightly moisten the fingers using hand cream and place the fingers on the sensor
again.
NOTE
Keep the FOOT REST button pressed until
the desired angle is achieved.
When massaging the soles or calves, adjust
the angle so that the massaging part of the
foot rest touches the soles or calves.
Keep the foot rest slide lever pulled while
adjusting the foot rest. When the foot rest slide
lever is released, the foot rest position is fixed.
(Sliding length of foot rest: approx. 11cm)
The foot rest is raised first, and
then goes down completely.
When the foot rest is suddenly released
after being raised by hand, it will return
forcibly to the previous position.
For safety, be sure to lower the foot rest
slowly using your hand.
WARNING
(Remote control)
Do not attempt to adjust the foot rest slide
during the operation of reclining.
Otherwise, the floor or tatami mat may be
damaged.
Do not attempt to stand on the foot rest
when the foot rest slide position and angle
is not completely returned to the home
position.
Otherwise, the user may fall over, resulting
in an accident or an injury, and the floor or
tatami mat may be damaged.
CAUTION
