647744
72
Verklein
Vergroot
Pagina terug
1/216
Pagina verder
72
Chapter 3. Creating Your Own Sounds
PATCH EFX OUT (Patch EFX Output)
These parameters specify the output for the Tone for which
EFX was selected in Output Assign.
* For Tones which have an Output Assign setting of MIX, the
settings of this display will be ignored.
Mix Out (EFX Output Level)
Adjust the volume level of the original sound and the Multi-
Effects sound.
Chorus (Chorus Send Level)
Adjust the amount of Chorus for the sound that passes
through Multi-Effects.
Reverb (Reverb Send Level)
Adjust the amount of Reverb for the sound that passes
through Multi-Effects.
PATCH EFX CTRL (Patch EFX Control)
Use this setting when you wish to use a specific controller to
control an EFX parameter. The EFX parameters available for
control will depend on the selected EFX type. For details
refer to Multi-Effects Types (EFX Parameter) (p. 93). The
upper line of the display will show the EFX parameters that
can be controlled. For each EFX parameter, you can specify
the EFX Control Source and the EFX Control Depth.
EFX Control Source 1, 2
The following MIDI controllers can be used. If you wish to
use a controller that will apply to all Patches, or a controller
that cannot be directly specified here, select SYS-CTRL1 or
SYS-CTRL2, and then select the controller using the Control
1/2 parameter (SYSTEM/CONTROL/SYS-CTRL ASSIGN).
OFF: controller not used
SYS-CTRL1: System controller (control 1)
SYS-CTRL2: System controller (control 2)
MODULATION: Modulation (MIDI controller number 1)
BREATH: Breath (MIDI controller number 2)
FOOT: Foot (MIDI controller number 4)
VOLUME: Volume (MIDI controller number 7)
PAN: Pan (MIDI controller number 10)
EXPRESSION: Expression (MIDI controller number 11)
BENDER: Pitch bend
AFTERTOUCH: Aftertouch
EFX Control Depth 1, 2
Adjust the amount of change that will occur in response to
controller movements. Higher settings will result in greater
change. Negative (-) settings will reverse the direction of
change.
PATCH CHORUS
These parameters control the Chorus effect of the Patch.
Rate (Chorus Rate)
Adjust the speed of modulation for the Chorus effect.
Depth (Chorus Depth)
Adjust the depth of modulation for the Chorus effect.
Delay (Chorus Pre Delay)
Adjust the time delay after the original sound begins until
the Chorus effect begins to apply. Higher settings result in a
more spacious effect.
Fbk (Chorus Feedback Level)
Adjust the amount of sound from the Chorus output that is
returned (fed back) to the Chorus. Higher settings result in a
more intense effect.
Level (Chorus Level)
Adjust the volume of the Chorus effect.
Out (Chorus Output Assign)
Select the way in which the Chorus and Reverb are
connected.
MIX: The Chorus sound and the Reverb sound are mixed.
fig.3-27.e
REV:Apply reverb to the chorus sound.
fig.3-28.e
M+R: Mix the chorus sound to which reverb is not applied
and the chorus sound to which reverb is applied.
fig.3-29.e
OUTPUT
Reverb
Chorus input
Chorus
Reverb input
OUTPUT
Reverb
input
Chorus
input
Chorus Reverb
OUTPUT
Reverb
input
Chorus
input
Chorus
Reverb
72

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Roland XP-30 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Roland XP-30 in de taal/talen: Engels als bijlage per email.

De handleiding is 5,26 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info