THR HOLD
This function sets the throttle cut position for
auto rotation. The throttle servo operating speed
can be adjusted. (Speed)
Note: Initially, this setting does not assign the
throttle hold switch. Prior to adjusting the
parameters for the throttle hold, we suggest
designating a throttle hold switch. To do so,
access the Condition menu within the Model
menu options.
●Servospeed
Setting method
●Hold condition switch selection
Use the Condition select menu of the Model
menu to assign the hold condition switch.
Selection example: SG
●Hold position adjustment
Move the cursor to the hold position item
and touch the RTN button to switch to the
data input mode.
Adjust the rate by scrolling the touch sensor.
Initialvalue:17%
Adjustmentrange:0%~50%
*Hold position sets the throttle cut position. Adjust it so that
the carburetor is completely closed.
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
Touch the RTN button to end the adjustment
and return to the cursor mode.
●Servo speed setting
Move the cursor to the servo speed item and
touch the RTN button to switch to the data
input mode.
Adjust the rate by scrolling the touch sensor.
Initial value: 0
Adjustment range: 0~27 (maximum delay)
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
Touch the RTN button to return to the cursor
mode.
●Select[THRHOLD]attheModelmenu
and access the setup screen shown
below by touching the RTN button.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Holdpositionsetting
●Holdposition
●Currentposition
Operation precautions
Warning
When actually starting the engine and flying,
always set the idle up condition switch to OFF
and start the engine at idle.
