587878
9
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
9
Electrical wiring
The units are operated with
230 V 50 Hz alternating current
The electrical
connection is made
using a built-in
mains cable with
earthed safety plug
Extensions to the connection
cable may only be carried out
by authorised electricians,
subject to the length of
the cable, connected load
of the unit and taking into
consideration how the unit is
used at its location
s
s
s
Control panel
All rotary knobs and the
corresponding indicator lights are
located on the control panel.
“Container full” display
“Hot gas defrosting” display
“Timer activated” display
Display for temperature
indication and timer setting
Display to show and adjust the
relative humidity
“Power ON/OFF” key
Key for fan speed
Key for “1 to 24 hrs” timer
(in 1 hour steps)
Key to adjust the hygrostat
from 30 to 90 % RH in 5 %
steps
Changeover button to display
in °C or °F
Switching the units on
Connect the unit's power plug
to a properly installed mains
socket
Press the power key []
Use the [] key to select the
(min/max) air volume
The electrical connection to the units
must be made at feed-points with
residual current devices in accordance
with VDE 0100, Section 704.
When installing the units in
extremely damp environments such
as laundry rooms, showers etc., the
unit must secured with a residual
current device provided by the
customer in accordance with the
regulations.
NOTE
In room temperatures
below
10 °C
and relative
humidity below
40 %
,
economical use of the unit can
no longer be guaranteed.
NOTE
When the units are connected
to the power supply, they beep
quickly and the displays flash
once.
NOTE
Adjusting the humidity level
The unit’s dehumidification power
is entirely dependent on the
conditions inside the room, the
room temperature, the relative
humidity and observance of the
notes in the “Set-up” chapter.
The higher the room temperature
and relative air humidity, the
higher the dehumidification power.
A relative humidity of around
45 to 60 % is recommended for
living rooms.
However, the air humidity
should not exceed 40 to 45 % in
warehouses, archives, etc.
Unit initial settings:
Fan speed = min.
Humidity = 60 % RH
Use the [] buttons to select
the required humidity (% RH)
The set value is shown on
the display [] for around
10 seconds
The humidity level can be
adjusted in 5 % steps
from 30 - 90 % RH
In normal operating mode, the
display [] shows the current
humidity level in % RH
The display [] shows the
current room temperature
in °C or °F
The display is changed over
using the [] key
All cable extensions must only
be used in fully un-reeled or
reeled off condition.
CAUTION
!
The units are only permitted
to be operated with the outlet
grill clear in order to prevent
overheating.
CAUTION
!
NOTE
At a humidity of < 30 %,
the “LO” indicator is shown
and, at > 90 %, the “HI” is
shown on the display [
]
.
9

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw REMKO ETF360 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van REMKO ETF360 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,77 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van REMKO ETF360

REMKO ETF360 Gebruiksaanwijzing - Nederlands - 20 pagina's

REMKO ETF360 Gebruiksaanwijzing - Deutsch - 20 pagina's

REMKO ETF360 Gebruiksaanwijzing - Français - 20 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info