779729

Prophete 0511 Handleiding

6
Verklein
Vergroot
Pagina terug
1/16
Pagina verder
taBle oF contents
1. scope
2. saFety and Maintenance
2.1 Safety instructions
2.2 Repairs
2.3 Operating environment conditions
2.4 Ambient temperature
2.5 Electromagnetic compatibility
2.6 Battery operation
2.7 Disposal
2.7.1 Battery disposal
2.7.2 Bicycle computer disposal
2.7.3 Packaging disposal
2.8 Maintenance
2.9 Cleaning and care
2.10 Storage
2.11 Notes to these operating instructions
2.12 Scope of delivery
3. display and Function keys
4. asseMBly
4.1 Bicycle computer mount and bicycle computer
4.2 Mounting the sensor
5. initial operation
5.1 Switchingonthebicyclecomputerforthersttime
5.2 Setting the wheel size
5.3 Selecting KM/H Miles
5.4 Setting the inspection interval
5.5 Setting the 12/24-hour display
5.6 Setting the clock
5.7 Bicycle computer check
5.8 New start/Reset
5.9 Automatic start/stop
6. Modes/Functions
6.1 Resetting the route data (DST, TM, AVS) to zero
6.2 Resetting the maximum speed (MXS) to zero
6.3 Manual entry of total kilometres
7. Battery replaceMent
7.1 Bicycle computer
8. declaration oF conForMity
9. description oF Fault
10. Warranty provisions
1. scope
This bicycle computer has been solely designed for use as a bicycle computer.
Bicycle computers provide information about the speed and covered distances.
Any other use than that described in these operating instructions is not permitted
and can cause damage and injuries. We shall not assume liability for damage
due to improper use. You will nd further notes and explanations in the operating
instructions.
2. saFety and Maintenance
2.1 Safetyinstructions
Please read this chapter carefully and comply with all given notes. This will
ensure reliable operation and the long service life of your bicycle computer.
Please keep the packaging and the operating instructions in a safe place in order
to pass them on to a new owner should you sell the bicycle computer. Never
open the housing of the bicycle computer and the sensor, as it does not contain
any parts requiring maintenance (opening the battery compartment to insert
or replace the batteries, see Point 7, Battery replacement, is the exception). Do
not place any objects on the bicycle computer and do not exert pressure on the
display. This could otherwise damage the display. Do not touch the display with
square-edged objects to avoid damage.
2.2 Repairs
In case of necessary repairs or a technical problem, please consult our Service
Centre. You will nd the address in Point 10, Warranty provisions.
2.3 Operatingenvironmentconditions
The bicycle computer is splash water protected. Make sure your bicycle computer
is not exposed to moisture or continuous high humidity and avoid dust, heat and
extended periods of direct sunlight. Non-compliance with these notes can cause
faults or damage to the bicycle computer.
2.4 Ambient temperature
The bicycle computer can be permanently operated and stored at ambient
temperatures of -10°C to 50°C.
2.5 Electromagnetic compatibility
If possible, do not use the bicycle computer in close proximity to, e.g. computers,
printers, television sets, mobile phones or radios, as devices with strong EMC
radiation can cause interference.
2.6 Battery operation
Your bicycle computer is operated by a 3V/CR2032 battery. In the following text
you will nd a few notes on how to handle batteries:
Replace the battery only with an equivalent battery type. Batteries may not be
charged or reactivated using other means, may not be taken apart, thrown into
a re or short-circuited. Always keep the battery out of the reach of children.
Batteries can be fatal if swallowed. Therefore, keep the battery and the bicycle
computer out of reach of small children. Seek medical assistance immediately if
a battery was swallowed. If required, use a slightly moist cloth to clean the device
and battery contacts and dry thoroughly before inserting the batteries. Be careful
with leaked batteries! Avoid contact with skin, eyes and mucous membranes!
If contact was made with battery uid, immediately rinse the affected spot with
plenty of water and consult your doctor directly. Batteries cannot tolerate heat.
Make sure to prevent the computer and its inserted batteries from becoming
too hot. Disregarding these notes can lead to damage and even cause the
batteries to explode. Temperatures below 0°C can have a negative effect on the
battery life. You will nd information on how to replace the batteries in Point 7,
Battery replacement.
Note: Please position the bicycle computer so that it is not exposed to
extreme heat or cold. Extreme cold weakens the batteries and thus the
transmission signal. (see 2.4)
2.7 Disposal
2.7.1 Battery disposal
Batteries are hazardous waste. To properly dispose of the batteries, stores selling
batteries and municipal collection points provide corresponding containers.
2.7.2 Bicycle computer disposal
If you would like to get rid of your bicycle computer, dispose of it as per current
regulations. Information can be obtained from the municipal ofce.
2.7.3 Packaging disposal
Dispose of the bicycle computer packaging as per current regulations. Informa-
tion can be obtained from the municipal ofce.
2.8 Maintenance
Caution! There are no parts that need to be maintained or cleaned inside
the housing of the bicycle computer.
2.9 Cleaningandcare
Only clean the bicycle cyclometer with a soft, moistened, lint-free cloth. Do
not use any solvents, corrosive or gaseous cleansing agents. Make sure that
water droplets do not remain on the display. Water can cause permanent
discolouration. Do not expose the bicycle computer display to erce sunlight or
ultraviolet radiation.
2.10 Storage
Remove the battery if you are not going to use the bicycle computer for an ex-
tended period of time. To store the bicycle computer, please observe the notes in
Point 2.3 Operating environment conditions, and Point 2.4 Ambient temperature.
The bicycle computer should be stored securely. Avoid high temperatures (e.g.
direct sunlight) and a permanently moist environment.
tautly or tears when turning the handlebar, and make sure that it does not
become entangled in the front-wheel spokes while riding the bicycle. If necessary,
x in place using the cable tie (G). Place the magnet on one of the front-wheel
spokes and attach with screw (E). Ensure that the magnet is aligned to the
sensor – with 2 mm clearance as depicted in the next gure.
G
BG
BC
E
B
E
B
C
E
5. initial operation
We recommend carefully reading the operating instructions rst before using
the bicycle computer.
5.1 Switchingonthebicyclecomputerforthersttime
A few settings must be made before the bicycle computer can be used for the rst
time. Press the LEFT or RIGHT key to switch on the bicycle computer. The rst item
to appear is the entry for the wheel size “2124”.
3. display and Function keys
4. asseMBly
4.1 Bicycle computer mount and bicycle computer
Place the securing aid (D) under the bicycle computer mount (A) on the handlebar
and attach using the cable tie (G). Slide the bicycle computer into the bicycle
computer mount from the front until it clicks into place. Then adjust the bicycle
computer (by turning) to the angle of view required. To remove the bicycle computer,
press the locking mechanism down.
G
D
A
A
G
A
4.2 Mountingthesensor
Place the anti-slip pad (C) under the sensor (B) and fasten everything in place –
using the cable tie (G) – underneath the bicycle computer on the fork, as depicted
in the following gure. Ensure that the cable is placed so that is not pulled too
Clearance to magnet 2 mm
2.11 Notes to these operating instructions
We have structured the operating instructions for this bicycle computer so that
you can consult the table of contents to nd the required, relevant information
at any time. If you have any further questions, you can also contact us at the
following address:
Service address: Prophete GmbH u. Co. KG
Lindenstraße 50
33378 Rheda-Wiedenbrück
+49 (0) 5242 4108-59
Email address: service@prophete.net
2.12 Scopeofdelivery
G
E
C D
F
AB
3V
CR2032
Bicycle computer
Issue 11/2014
LEFT key RIGHT key
A Bicycle computer mount
B Sensor
C Anti-slip pad
D Securing aid
E Magnet with screw
F 3 V battery CR2032
G Cable tie
BAFahrradPC0511_DE-FR-GB-IT-NL-HU-RO-PL.indb 2 11.11.2014 15:41:52
… 6 …

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Prophete 0511 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Prophete 0511 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Pools als bijlage per email.

De handleiding is 5.21 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info