POWX075710S EN
Copyright © 2022 VARO P a g e | 9 www.varo.com
9.8 Switching ON / OFF
For your safety use both hands to switch the power tool on and off.
▪ Connect the power tool to the power supply.
▪ Unlock the lock-off button and depress the on/off switch (15) in the direction of the handle.
The saw blade rotates as long as you keep the switch engaged.
▪ When you want to turn off the machine, you have to release the on/off switch (15).
9.9 Laser
▪ You can switch the laser ON and OFF with the switch (12)
▪ The laser (23) directs a beam onto the workpiece
▪ Extremely precise cuts can be made using the laser function.
9.10 Dust bag
To attach the dust bag (18), fit it onto the dust extraction adapter. When the dust bag is about
half full, remove the dust bag from the tool and empty it.
9.11 Sawing
Make sure the saw blade doesn’t block while you are sawing. It causes
damage to and burning of the motor. If there is a blockade of the saw blade,
please loosen the switch immediately to prevent damage at the motor.
▪ Clamp the work piece firmly.
▪ Set the required horizontal mitre angle or the required vertical bevel angle.
▪ Switch on the power tool.
▪ Move the handle (14) slowly downwards. You have to push the safety switch (16) before
you can do this.
▪ Saw trough the work piece.
▪ Switch off the power tool.
▪ Wait until the saw blade (2) has come to a complete standstill before removing the work
piece.
9.12 Sawing special work pieces
Curved or round work pieces need to be secured against slipping.
Make sure there is no gap between the work piece and the fence (4) or the saw table (5).
9.13 Replacing the saw blade (Fig. 1)
Disconnect the tool from the outlet before working on the saw blade.
Wait a while before touching the saw blade. It can be very hot.
The teeth of the saw blade are very sharp.
▪ Press the blade guard release lever (16) and then rotate the lower retractable blade guard
(1) upwards to expose the screw.
▪ Loosen the screw on the guard mounting plate with the provided multi tool.
▪ Slide the guard mounting plate upwards to expose the saw blade (2). The lower
retractable blade guard (1) will be held by the blade guard the lower retractable blade
guard (1) will be held by the blade guard.
▪ Press the spindle lock button (24) fully and hold it in position.
▪ Turn the clamping screw slightly with the provided multi tool until the spindle is locked.
