POWX075710S EN
Copyright © 2022 VARO P a g e | 7 www.varo.com
▪ Do not maltreat the cable. Never pull on the cable, for removing the plug from the socket.
Do not expose the cable to heat, oil, water or sharp edges.
▪ Some types of dust that is generated while working with the saw may contain chemicals,
which can cause cancer, birth defects or other genetic damages. Some examples of these
substances are:
▪ Lead derived from paints containing lead;
▪ Arsenic and chrome from chemically treated wood.
▪ The hazard to your health from such exposures is dependent on how frequently you do
this kind of work.
▪ Measures for reducing your exposure to such chemicals: Always work in well-ventilated
surroundings and with certified safety equipment, such as dust masks that have been
specially designed for filtering out microscopic particles.
▪ For sawing operations, connect the equipment to a dust exhaust system.
▪ The guard may be lifted up while positioning a workpiece, or for easier access during
maintenance works. Make sure that the saw guard has been lowered and is positioned flat
against the sawing table, before connecting your tool to the mains supply.
▪ Ensure that the equipment for swinging the arm on mitre saws is securely fastened.
▪ The floor around the machine must be flat, clean and clear of loose particles such as ships
and off-cuts.
7 ADDITIONAL SAFETY INSTRUCTIONS FOR LASERS
Warning! The laser beam potentially causes eye damage. Do not look or
stare into the laser beam.
▪ During use, do not point the laser beam at people, directly or indirectly through reflecting
surfaces.
▪ This laser complies with class 2 according to the relevant standard. The unit includes no
servicing components. Do not open the housing for any reason. If the unit is damaged,
have the damage repaired by an authorized repair agent.
▪ Laser viewing glasses are not protective glasses against laser radiation.
8 ASSEMBLY
Disconnect the power plug before carrying out any adjustments or
maintenance.
Do not operate this mitre saw until it has been fully assembled and correctly prepared for use
in accordance with this instruction manual.
8.1 Assembling the side support bars
▪ Place the two guide rails into the side supports and secure them.
▪ Loosen the screw and place the side support bars into the positioning holes.
▪ Secure the side support bars with the screw to prevent them sliding out of position.
8.2 Assembling the clamp
The clamp (11) can be installed on either left or right side of the guide fence. Insert the vise
rod into the hole in the guide fence and fasten with locking screw
9 OPERATING INSTRUCTIONS
9.1 Transporting the mitre saw
To transport the power tool, use the retaining pin (17).
