POWX075710S EN
Copyright © 2022 VARO P a g e | 8 www.varo.com
Pull the mitre saw downwards and lock it in the lowered position by pushing in the retaining
pin. That way, the saw is secured.
9.2 Dust and chip extraction
For integrated dust extraction, place the dust bag (18) on the sawdust outlet.
For external dust, you can use a vacuum cleaner hose.
The dust bag is only for a partial dust removal! It is designed to break the
dust extraction.
9.3 Clamping the work piece
Make sure the work piece can’t be catapulted. The clamp(11) is the most perfect gadget to
avoid this.
▪ Press the work piece against the fence (4) and between the clamp
▪ Tighten the clamp (11) clockwise to secure the work piece.
9.4 Horizontal mitre angle
The horizontal mitre angle can be set in the range from -45° to 45°. The horizontal mitre angle
scale shows the currently set in degrees.
▪ To adjust the mitre angle, loosen the turntable locking handle (26) anticlockwise and uplift
the adjustment lever (6).
▪ Then rotate the mitre table to the desired position.
▪ The mitre table features positive click stops at 0°, 15°, 22,5°, 31,6° and 45° for quick
setting of the common angels.
9.5 Adjusting of the cutting angle
▪ Position the saw in the lower position and block it with the retaining pin.
▪ Now hold the try square (90°) against the guide rail and the saw blade. The latter must
make complete contact with the try square. If this is not the case, then you can adjust the
angle by loosening the counter nut and adjust with adjustment bolts until the angle
between the blade and the turn table equals 90°.
▪ To carry out this step, use the delivered key for loosening the screws. Do not forget to re-
tighten the screws afterwards.
9.6 Vertical bevel angle
The vertical bevel angle can be set in the range of 0° to 45°. The vertical bevel scale shows
the currently set in degrees.
▪ Loosen the locking lever (20), if tightened.
▪ Swing the tool arm with the handle to the required angle.
▪ Tighten the locking lever (20).
▪ Place a protractor at the side of the saw blade and table, if the angle is not 45° bevel
angle. Adjusting the height of the adjustment screw until the bevel angle is the correct
angle. Finally tighten the nut and check the angle once more.
9.7 Slide lock adjustment
▪ To unlock and lock the slide bar (13), turn the slide bar lock knob (21) counterclockwise or
clockwise
For long workpieces you should use the slide; loosen the locking knob for this purpose.
▪ Saw trough the work piece.
▪ Switch off the power tool.
▪ Wait until the saw blade (2) has come to a complete standstill before removing the work
piece.
