63124
16
Verklein
Vergroot
Pagina terug
1/23
Pagina verder
1212
BASIC
CONNECTIONS
BASIC
OPERATION
ADVANCED
CONNECTION
ADVANCED
OPERATION
TROUBLESHOOTING
OTHERS
NAMES AND
FUNCTIONS
ADVANCED
CONNECTION
ENGLISH
ADVANCED CONNECTION
CONNECTING THE REMOTE CONTROL JACKS
PHONO
PHONO
R
R
L
L
SWIT
CSWITCHED
150W 0.6
5150W 0.65A MAX.
AC OU
TAC OUTLET
230V
5230V 50/60Hz
PHONO GND
PHONO GND
CD
CD
DVD
DVD
DSS
DSS
AUX
AUX
RECORDER 1
RECORDER 1
R
R
L
L
R
R
L
L
IN
IN
IN
IN
IN
IN
IN
IN
IN
IN
IN
IN
OUT
OUT
(CD-R)
(CD-R)
SUB WOOFER
SUB WOOFER
PRE OUT
PRE OUT
L
L
R
R
SPEAKERS IMPEDANCE : 8-16 OHMS
SPEAKERS IMPEDANCE : 8-16 OHMS
SPEAKER SYSTEMS
SPEAKER SYSTEMS
N
N
MODEL NO. SR5023
MODEL NO. SR5023
GND
GND
AM
AM
FM
FM
(
(
75
75
Ω
Ω
)
)
ANTENNA
ANTENNA
REMOTE CONTROL
REMOTE CONTROL
IN
IN
OUT
OUT
REMOTE
CONTROL
REMOTE
CONTROL
REMOTE
CONTROL
IN
OUT
IN
OUT
IN
OUT
EXTERNAL INTERNAL
EXTERNAL INTERNAL
EXTERNAL INTERNAL
CD player
CD recorder
DVD player
q
You can control other Marantz products through
this unit with the remote control by connecting the
REMOTE CONTROL terminals on each unit.
The signal transmitted from the remote control is
received by the remote sensor on this unit. Then the
signal is sent to the connected device through this
terminal. Therefore you only need to aim the remote
at one unit. Also, if a Marantz power amplifi er (some
models excluded) is connected to one of these
terminals, the power amplifier’s, power switch is
synchronized with this unit’s power switch.
Set the REMOTE CONTROL SWITCH on the units,
other than the main unit to EXT.(EXTERNAL) for this
feature.
w
Whenever external infrared sensors or similar
devices are connected to RC-5 IN of the SR5023,
be sure to always disable operation of the infrared
sensor on the main unit by using the following
procedure.
1.
Hold down the S-DIRECT button and BAND
button on the front panel at the same time for 3
seconds.
2.
The setting “IR=ENABLE” is shown on the FL
DISPLAY.
3.
Press TUNING/PRESET 3 or 4 button to
change this to “IR=DISABLE”.
4.
Press the MUTE button. Once this setting is
made, the infrared sensor on the main unit is
disabled.
Note:
Be sure to set to “IR=ENABLE” when external
infrared sensors or similar devices are not connected.
Otherwise, the main unit will be unable to receive
remote control commands.
5.
To restore the original setting, perform steps 1
to 4 to set to “IR=ENABLE”.
ADVANCED OPERATION
RECORDING A SOURCE
In normal operation, the audio source selected for
listening through the SR5023 is sent to the record
outputs.
This means that any program you are watching
or listening to may be recorded simply by placing
machines connected to the outputs for RECORDER
OUT in the record mode.
To record the input source signal you are currently
watching or listening to
D
S
1.
Select the input source to record by turning the
corresponding input selector.
The input source is now selected and you may
watch or listen to it as desired.
2.
The currently selected input source signal is
output to the
RECORDER
output for recording.
3.
Start recording to the recording component as
desired.
AMPLIFIER OPERATION
USING THE SLEEP TIMER
To program this unit for automatic standby, press the
SLEEP button on the remote controller.
Each press of the button will increase the time before
shut down in the following sequence.
OFF 10 20 30 50
40
120 90 80 70 60100110
The sleep time will be shown for a few seconds in the
display on the front panel, and it will count down until
the time has elapsed.
When the programmed sleep time has elapsed, the
unit will automatically turn off.
Note that the SLEEP indicator on the display will
illuminate when the Sleep function is programmed.
To cancel the Sleep function, press the SLEEP
button until the display shows “SLEEP OFF” and the
SLEEP indicator will disappear.
16

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Marantz-SR5023

Zoeken resetten

  • Bij het inschakelen springt hij op PROTECT, gaat het standby-lampje knipperen en kan ik verder niets meer. Hoe dit te verhelpen? Gesteld op 16-9-2012 om 18:39

    Reageer op deze vraag Misbruik melden
    • Ook mijn Marantz receiver SR5023 springt de laatste maan op 'protect' bij het inschakelen.

      Na enkele malen via de afstandsbediening opnieuw pogen lukt het pas.

      Ik kan in de handleiding of op internet nergens de reden vinden.

      Pierre Hendriks Geantwoord op 28-9-2013 om 16:33

      Waardeer dit antwoord (9) Misbruik melden
    • Ook ik heb dit probleem nu. Soms springt na circa een halve minuut de radio toch aan. Soms blijft het lampje knipperen en gebeurd er niets. Draai ik dan aan de grote linker knop richting bijvoorbeeld CD dan gaat de radio wel aan. Maar goed lijkt mij dit niet. Vandaag een monteur laten kijken. Meer dan drie seconden de s-direct toets en de mute-toets gelijktijdig ingedrukt houden. Er vind een soort van reset plaats. Maar ook dit heeft niet geholpen. Heeft iemand een idee hoe dit op te lossen. Ik wil evt. de monteur wel weer inschakelen, maar ben bang dat het duur wordt. Dit apparaat nu 2,5 jaar in bezit, dus de garantie zal wel verlopen zijn? Geantwoord op 8-10-2014 om 20:41

      Waardeer dit antwoord (22) Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Marantz SR5023 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Marantz SR5023 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,35 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Marantz SR5023

Marantz SR5023 Gebruiksaanwijzing - Nederlands - 18 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info