14
10X MANUAL Heli
At the beginning of each code function in this manual, there is a
brief explanation of the code and its significance to your heli-
copter. It’s important that you comprehend each code completely
prior to moving on to the next code.
Code # Display Program Description
11 Reverse SW
Servo reversing switches—all channels
12 Travel adjust Endpoint-travel adj.—all channels
13
D/
R & EXP Dual Rate & Exponential adjustment—
Elev./Aileron/Rudder
15 Sub-Trim Electronic means of centering all channels
16 Throttle Hold Throttle hold position adjustments and throttle
hold delay settings
17 Function Select Selection of flight modes 3 and 4, gear,
Aux 2, low pitch, and high pitch switches
and levers, as well as Digital Trim inhibit
function
18 Throttle Curve Throttle curve settings
23 Auto Dual Rate Automatic dual rate selection and adjustments
28 Data Reset Individual program erasure and reset
41 Rudder
➝
Throt Mix Adjusts throttle when rudder is applied
42 Aileron
➝
Throt Mix Adjusts throttle when aileron is applied
43 Elevator
➝
Throt Mix Adjusts throttle when elevator is applied
44 Gyro Sens Adj. Gyro sensitivity adjustments;
three available rates
47 Tail Curve Revolution mixing selection and adjustment
with multi-point tail curves for stunt
modes 1–4
51-54 Standard Prog. Mix Program mixing selection and adjustments
55-58 Multi-Point Prog. Mix Up to 6 point programmable curve
65 Swash Mixing/Type Swashplate mixing selection and adjustments;
independent swashplate timing adjustments
available for both aileron and elevator. CCPM
mixing 120° and 140° 3 servo is also avaliable
68 Pitch Curve Pitch curve selection and adjustments
75 Servo Monitor Servo monitor gives visual indication of all
servo positions plus Servo Test—Slow & Step
77 Fail-Safe Fail-safe memory & settings
81 Model Name Model name memory input
82 Trim Offset Trim offset correction adjustments
83 Trim Rate Trim travel authority selection & adjustments
from 100–0% in 1% increments
84 Model Select/Copy Model Memory selections (1–10), Copy
Function
85 Modulation Modulation Selection (
SPCM
,
ZPCM, PPM)
86 Data Transfer Model memory transfer to/from another
PCM10X or DataSafe
87 Timer Countdown timer & Tx on time reset
88 Keyboard Lock Keyboard lock password selection
Code Function
8
