Reversing Switches
This is an electronic means of reversing the throw of a given
(servo) channel. All ten (10) channels of the PCM10X offer
reversible servo direction. This will ease setup during the servo
installation into your helicopter.
Accessing and Utilizing the Servo
Reversing Feature
Prior to accessing the servo reversing feature, determine which
servos’ travel needs to be reversed. To do so, move the controls
of your
PCM10X and observe the travel direction of each servo.
If the respective servo is not moving properly, i.e., not in accor-
dance with the control input, then reverse its direction.
Upon determining which channels need to be reversed, access
the servo reversing feature by entering Code 11 in the code num-
ber access selection or by using the direct mode method.
The screen will appear as follows:
To reverse the travel direction of any servo (channel), simply
touch the number which correlates to that channel. Note that the
shaded portion of the upper box moves to the opposite position.
This indicates the travel has been reversed.
Upon completing the servo’s travel direction, press
ENTER to exit
this feature and memorize the servo travel direction.
Note: All servo directions are set to their normal throw at the
factory and are set at the default positions (Code 28 or clear).
10X MANUAL Heli
15
Indicates which code is
being programmed
Touch to
memorize data and
exit program
Depiction of servo
travel direction
Respective channel
number. Touch to reverse
servo travel direction
Denotes travel direction (NOTE: If upper
area is shaded, travel is reversed; If lower
area is shaded, then travel is normal
