NOTE: For our system to detect the correct flow data and reflect it on your Dashboard reports, any third-party
flow meter used must be a true pulse flow meter or have a reed switch. We aim for a minimum of 10 pulses per
min and a maximum of 120 pulses per min. That means if the flow rate was 10 gal per min, 1 pulse per gallon
needs to be set.
When using a third-party flow meter, please ensure it meets the specs above and is
calibrated correctly. Otherwise, data will not reflect accurately in reports. Also, note that the
wiring is not polarity sensitive. As long as you have one wire in a Sensor Port and a
Sensor Common, the device will work correctly. For flow meters that use three wires and
meet the specs above, configure the wiring until you find the two correct wires to use.
Using One Flow Meter for Two
Controllers
For this installation, we suggest a few tips to make sure you do not receive any
