502558
31
Verklein
Vergroot
Pagina terug
1/68
Pagina verder
SYSTEM CONFIGURATION 31
ENGLISH
System Configuration
Step 7a. If the measurements are not successful
due to a missing or malfunctioning speaker, the
FAR FIELD EQERRORmessage will
appear as shown in Figure 17e. EzSet/EQ is pro-
grammed to look for speaker pairs at the front
left/front right, surround left/surround right and
surround back left/surround back right positions.
If the test results indicate that one, but not both
of the speakers in any of these pairs is present,
the menu will show
NOnext to the speaker
position where the tests did not report back that
a speaker is present. Should this message appear,
make note of the suspect speaker location, exit
all menus and turn the receiver off. Check all
speaker wire connections and then rerun
EzSet/EQ.
Figure 17e
Step 7b. In some cases, the system may not
function properly due to overly high output
levels. When this occurs, you will see the
message shown in Figure 17f. If you see this
message verify that that the microphone is in the
correct position, and not too close to any one
speaker. Then press the Set Button
F
to go
back to the
MASTER MENU. From there,
return to the EzSet/EQ system and when you are
once again at the
FAR FIELD MEASURE
screen, reduce the system volume level by 3dB
before trying EzSet/EQ again.
Figure 17f
Step 8. When the Far Field measurements are
completed, the system will ask you to take three
Near Field measurements, one at each front
speaker position. These measurements enable
EzSet/EQ to produce the most accurate settings
for both high and low frequency equalization.
The Near Field measurements are similar to the
Far Field tests, except that the system will
“listen” to only one speaker at a time, rather
than sending the test signals to all speakers in
rotation.
At the
NEAR FIELD EQSELECTmenu
(Figure 17g) that should be on your screen after
completing the instructions in Step 6, press the
Set Button
F
to start the near field measure-
ments with the front left speaker. If you are
repeating the setup process, you may also use
the
/
¤
Navigation Button
E
to select
any of the three speaker positions shown.
Figure 17g
At the NEAR FIELD EQSELECTmenu
(Figure 17g), you will see an instruction to place
the microphone in a different position than the
one used for the initial Far Field measurements.
This time, place the microphone close to the
speaker to be measured, at a distance of about
60 cm. In addition, the top of the microphone
should be pointed towards the speaker, rather
than pointing up as was done for the Far Field
tests. For the first measurement, place the micro-
phone so that it is close to, and pointing
towards, the front left speaker, and with the on-
screen cursor pointing to
1.FL
SPEAKER
, and press the Set Button
F
.
Step 9. You will now see a Warning message
similar to the one shown in Figure 17c except
that it will contain an option to return to the
NEAR FIELD EQSELECTmenu (Figure
17g) as well as the ability to return to the
MASTER MENU. If you are ready to proceed
with the test, make certain that the microphone
is properly pointed toward the speaker selected
for calibration, press the
Navigation Button
E
so that ONis highlighted and press the Set
Button
F
.
Step 10. One short test signal will be sent to the
speaker position being calibrated and after a
slight pause fro the system to calculate the test
results, you will see either a “Near Field
Complete” message or a “Near Field Error”
message. In most cases, the “Complete”
message will appear, in which case you should
proceed to Step 11, if an “Error” message
appears, go to Step 12.
Step 11. If the test results were successful, the
message shown in Figure 17h will appear. In
order to properly calibrate the system, you will
need to run the Near Field tests for all three front
channel speakers (left, center and right). After
running the test for the front left speaker, make
certain that the cursor is pointing towards
BACK TO NEAR FIELDand press the Set
Button
F
. When you are taken back to the
Near Field Select menu (Figure 17g) where you
should repeat Steps 8 through 11 until all three
front speakers have been calibrated. When that is
done the EzSet/EQ process is complete and you
should press the
¤
Navigation Button
E
to
return to the Master Menu.
Figure 17h
Step 12. If a “Near Field Error” message
appears, as shown in Figure 17i, you should
check to make certain that the microphone is
about 60 cm from the speaker being tested and
that the top of the microphone unit is pointing
towards the speaker. You may also have to raise
or lower the master volume to achieve accurate
readings. After checking these two items, as
needed, make certain that the cursor is pointing
to the
BACK TO NEAR FIELDline and
press the Set Button
F
. This will return you to
the
NEAR FIELD EQSELECTmenu
(Figure 17g) where you should repeat Steps 8
through 11, adjusting the mike placement and
volume level as needed until the
NEAR
FIELD COMPLETE
menu (Figure 17h)
appears after the test tone stops.
* NEAR FIELD COMPLETE *
EZSET/EQ has success-
Fully performed
Near Field Eq for
the selected speaker.
BACK TO NEAR FIELD
BACK TO MASTER MENU
* NEAR FIELD EQ SELECT *
Please select
1. FL Speaker
2. C Speaker
3. FR Speaker
BACK TO MASTER MENU
* EZSET/EQ ERROR *
An overload was
detected. Please
verify mic position.
Reduce the volume by
6dB and repeat the
procedure.
BACK TO MASTER MENU
* FAR FIELD EQ ERROR *
Detected speaker config
FL : YES SBR: YES
CEN : YES SBL: YES
FR : YES SL : YES
SR : NO SUB: YES
Verify spkr connections
Verify mic position
Reduce background noise
BACK TO MASTER MENU
29851_AVR645_ENG 30/10/06 9:46 Side 31
31

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Harman Kardon AVR645 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Harman Kardon AVR645 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,33 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Harman Kardon AVR645

Harman Kardon AVR645 Gebruiksaanwijzing - Nederlands - 68 pagina's

Harman Kardon AVR645 Gebruiksaanwijzing - Deutsch - 68 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info