502558
26
Verklein
Vergroot
Pagina terug
1/68
Pagina verder
26 SYSTEM CONFIGURATION
System Configuration
When the adjustment has been made, or if no
adjustment is required and all settings on this
page are complete, press the
/
¤
Navigation
Button
E
F until the on-screen cursor is
pointing to
PAGE 1 and then press the
Set Button
F
Q to return to the main
IN/OUT SETUP menu to configure another
input, or if no further input configuration adjust-
ments are needed, press the
/
¤
Navigation
Button
E
F until the on-screen cursor is
pointing to
MASTER MENU and then press
the Set Button
F
Q to return to the main
menu screen.
Video Monitor Settings
The VIDEO MONITOR SETTINGS
menu (Figure 10) is unique in that it contains a
mix of information display lines that detail status
information about the AVR 645’s video system
settings, along with a few lines where a specific
parameter may be changed. With the
MASTER
MENU
on the screen, press the
/
¤
Navigation Button
E
F until the on-
screen cursor is pointing to
VIDEO
MONITOR SETTINGS
and then press the
Set Button
F
Q to move to the menu
screen.
Figure 10
The IN VIDEOFORMAT line is an informa-
tional display of the resolution of the incoming
video stream, and may not be adjusted.
The
IN VIDEO COPYPROT line is an
informational display that shows whether or not
an incoming video signal contains copy
protection encoding, and may not be adjusted.
The
VIDEO PROCESS line is an informa-
tional display of the setting made in the
IN/OUT SETUP menu indicating how
incoming video is processed for the input being
viewed, and may not be adjusted.
The
COMPONENT OUT line is an informa-
tional display of whether or not the Component
Video outputs are
ENABLED or OFF, based
on the input signal type and resolution, and
whether or not the incoming video signal has
HDCP content protection. It may not be adjusted.
The
S-VIDEO OUT line is an informational
display of whether or not the S-video outputs are
available at a 576i resolution (or OFF), based on
the input signal type and resolution and whether
or not the incoming video signal has HDCP
content protection. It may not be adjusted.
The
DISPLAY INTER line allows you to
choose between an
ANALOG video output
default value and an HDMI/DVI output by press-
ing the
/
Navigation Button
E
F to
make the desired selection. When the setting is
ANALOG, the HDMI output is placed in a
Standby mode so that it automatically switches
to HDMI when an HDMI signal is detected. If a
high-definition input source is not HDCP-content-
protected, it may be output through the compo-
nent jacks; otherwise, it will be sent only to the
HDMI outputs. The
HDMI/DVI setting routes
all converted or processed video to the HDMI
outputs.
The HDMI AUDIO OUT line allows you to
choose whether a two-channel downmix of the
audio that accompanies the selected source is
sent over the HDMI connection (
YES) at the
maximum bit rate the display’s audio system is
capable of handling, or not (
NO). To change the
setting, press the
/
Navigation Button
E
F to make the desired selection.
When required adjustments have been made for
this input, or if no adjustment is required, press
the
/
¤
Navigation Button
E
F until
the on-screen cursor is pointing to
BACK TO
MASTER MENU
and then press Set Button
F
Q to return to the main menu screen.
Audio Setup
This menu allows you to configure the tone con-
trols. If you do not wish to change any of those
settings at this time, proceed to the next menu
screen. However, to make configuration changes
to those parameters, make certain that the
MASTER MENU is on the screen with the
cursor pointing to the
AUDIO SETUP line,
and press the Set Button
F
Q.The
AUDIO SETUP menu (Figure 12) will appear.
Figure 12
The first line controls whether or not the
bass/treble tone controls are in the signal path.
The normal default is for them to be in-line, but if
you wish to remove them from the circuit for
“flat” response, first make certain that the
cursor is pointing to the
TONE line on the
menu and press the
/
Navigation Button
E
F so that OUT is highlighted in reverse
video.
If you wish to leave the tone controls in the sig-
nal path, the amount off boost or cut for bass
and treble may be adjusted by pressing the
/
¤
Navigation Button
E
F so that the
cursor is next to the line for the setting you
wish to adjust. Next, press the
/
Navigation
Button
E
F until the desired setting is
shown.
When all desired changes have been made on
this menu, press the
/
¤
Navigation Button
E
F so that the cursor is next to the
BACK TO MAIN MENUline and press
the Set Button
F
Q.
* AUDIO SETUP *
TONE :IN OUT
BASS :0
TREBLE :0
BACK TO MASTER MENU
*VIDEO MONITOR SETTINGS*
IN VIDEO FORMAT: 1080i
IN VIDEO COPY PROT: ON
VIDEO PROCESS: V CONVERS
COMPONENT OUT: OFF
S-VIDEO OUT: OFF
COMPOSITE OUT: OFF
DISPLAY INTER: HDMI/DVI
HDMI AUDIO OUT: NO
BACK TO MASTER MENU
29851_AVR645_ENG 30/10/06 9:46 Side 26
26

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Harman Kardon AVR645 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Harman Kardon AVR645 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,33 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Harman Kardon AVR645

Harman Kardon AVR645 Gebruiksaanwijzing - Nederlands - 68 pagina's

Harman Kardon AVR645 Gebruiksaanwijzing - Deutsch - 68 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info