633026
8
Verklein
Vergroot
Pagina terug
1/16
Pagina verder
8
5.0 - DESCRIPTION OF THE ALARM SYSTEM ARMING/DISARMING
COMMAND WIRES
6.0 - DOORS LOCK/UNLOCK SIGNALS SELF-CODING
A - Using the RED/BROWN and RED/GREY wires you can arm and disarm the alarm
using the original vehicle remote, or door key lock.
- RED/BROWN WIRE: Connect to the vehicle wire that changes state when locking the doors.
- RED/GREY WIRE: Connect to the vehicle wire that changes state when unlocking the
doors.
Note: with this connection the YELLOW/BROWN and YELLOW/GREY wires have to be
connected to O/E vehicle earth.
B - Using the RED/BROWN, RED/GREY, YELLOW/BROWN and YELLOW/GREY wires,
the alarm will only arm and disarm using the original vehicle remote. YELLOW/BROWN
and YELLOW/GREY wire connections can be found in the vehicle technical guides
supplied by GT.
- YELLOW/BROWN WIRE: This wire has to be connected to the vehicle’s locking wire which
is only present when the door lock is being operated by the original vehicle remote.
- YELLOW/GREY WIRE: This wire has to be connected to the vehicle’s unlocking wire which
is only present when the door lock is being operated by the original vehicle remote.
WARNING:
- Ensure that the RED/BROWN, the YELLOW/BROWN, the RED/GREY and the YELLOW/
GREY wires are correctly connected (as indicated in the GT vehicle installation guides
or following the DESCRIPTION OF THE ALARM SYSTEM ARMING/DISARMING
COMMAND WIRES section), the ignition key must be in off and the alarm disarmed.
1- Earth the GREEN/YELLOW wire until the alarm system will emit a long acoustic signal and
the LED BUTTON starts to flash.
2 - During the next 10 seconds disconnect and then reconnect the earth to the GREEN/
YELLOW wire.
Note: after 10 seconds the alarm system will emit 3 visual (indicators)/acoustic signals and
automatically start the RAPID TEST procedure.
3 - At this point the system will emit 6 visual (indicators) /acoustic signals to indicate that it is
in condition to SELF-CODE THE DOORS LOCK (arming) AND UNLOCK (disarming)
SIGNALS; when the LED BUTTON starts flashing you have 2 minutes to carry out the points
4, 5 and 6.
4 - Make sure that all the doors and the boot and bonnet closed.
5 - Lock the vehicle using the original remote control, after a couple of seconds the alarm will
emit 1 visual (indicators)/acoustic signal and the doors will lock.
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw GT 800-2 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van GT 800-2 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,22 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info