68 Ferm
Vi erklærer herved, udelukkende på eget ansvar, at dette produkt opfylder følgende standarder
eller standardiserede dokumenter:
EN60745-1, EN60745-2-4, EN55014-1, EN55014-2, EN61000-3-2, EN61000-3-3
i overenstemmelse med direktivreglerne
98/37/EEC, 73/23/EEC, 89/336/EEC
01-02-2006
ZWOLLE NL
W. Kamphof
Quality department
Det er vores hensigt til stadighed at forbedre vores produkter, og vi forbeholder os derfor til
enhver tid retten til at ændre produktspecifikationerne uden forudgående varsel.
Ferm BV • Lingenstraat 6 • 8028 PM Zwolle • Holland
CE KONFORMITETSERKLÆRING (DK)
UK
D
NL
F
E
P
I
S
SF
N
DK
Ferm 5
• Use safety glasses, especially when sanding above your head.
Electrical safety
When using electric machines always observe the safety regulations applicable in your country
to reduce the risk of fire, electric shock and personal injury. Read the following safety
instructions and also the enclosed safety instructions.
Keep these instructions in a safe place!
Always check that the power supply corresponds to the voltage on the rating plate.
The machine is double insulated in accordance with EN50144; therefore no earth
wire is required.
Replacing cables or plugs
If the mains cable becomes damaged, it must be replaced with a special mains cable available
from the manufacturer or the manufacturer’s customer service. Dispose of old cables or plugs
immediately after replacing them with new ones. It is dangerous to connect the plug of a loose
cable to a socket.
Using extension cables
Only use an approved extension cable suitable for the power input of the machine. The
minimum conductor size is 1.5 mm2. When using a cable reel always unwind the reel
completely.
Dust collection
Fig. 2
The sander has been carried out with a dust bag (3) to keep the working surface clean. The dust
bag must be installed on the back side of the machine, on the opening. It is necessary to empty
the dust bag regularly for an efficient use.
Empty it as follows:
• Turn the dust bag slightly and pull it out of the machine’s adapter.
• Empty the dust bag in a suitable place.
• Push the dust bag on to the machine’s adapter till it locks into place.
Remember that the dust extraction only works when using perforated sandpaper.
Replacing worn sanding paper (ø125mm)
Fig. 3
Before assembly sanding paper always remove the plug from the mains.
3. ASSEMBLY
GB
D
NL
F
E
P
I
S
SF
N
DK
