• Pull out the power cable until it has the required length, then place the motor block
onto an even surface close to the mains socket.
• Assemble the mincing machine as follows:
- Feed screw - coupling on the inside,
- Set the blade onto the bolt of the screw so that the cutting edges point towards the
attachment.
- Place the attachment into the mincer casing so that the notch in the attachment
meets the casing overhang,
- Then affix all parts using the closing ring.
A
TTENTION:
The notch in the attachment must meet the
overhang.
Incorrect closing of the closing ring will impair
the quality of the minced goods and can also
cause the attachment and the blade to beco-
me blunt.
• Place the mincer casing (1) onto the cou-
pling (2) and turn it into position until you
hear it click into place.
It is advisable to exchange blunt knives
and attachments.
• Place the tray with the filling shaft and the
food pusher onto the mincer casing.
• Connect plug to mains socket.
• Switch on the mincing machine by pressing
the switch.
After you have finished:
• Switch off the motor by pressing the switch
again.
• Disconnect the plug from the mains socket.
• Remove the tray with the filling shaft.
• Press the release key (1) and turn the
whole casing (2) to the right and then
remove.
• Remove the casing parts in reverse order
to assembly procedure.
13
Operation and use
