INTRODUCTION-About the STB
2
• Remove the battery compartment cover.
• Load two AAA (UM-4 or R03) batteries into the battery
compartment.
• Make sure that the batteries have been inserted with the
correct polarities matching to the symbols +, - marked in
the battery compartment. Close the battery compartment
cover.
• When replacing batteries, replace both batteries. Do not
mix new and used batteries operating together, otherwise,
the operation lifetime will be much shorter than normal.
• Remove the batteries if the unit will not be used for a
prolonged period of time.
The remote control transmits a directional infrared beam. Be
sure to aim the remote control directly at the infrared sensor
of the unit during operation.
If the sensor has been covered or there is a large object
between the remote control and the sensor, the sensor will
not respond.
The sensor may not able to receive the remote signal when it
is exposed to direct sunlight or a strong artificial light
(fluorescent or strobe light). In this case, change the direction
of the light or reposition the unit to avoid direct lighting.
Using Remote control
Within approximately
6 meter (20 feet)
Remote sensor
BE ENVIRONMENTALLY FRIENDLY
Do not dispose batteries as normal rubbish. Be
environmentally friendly, dispose batteries following
the Government's regulation.
DSD-800M_UK_2007 2007.10.2 5:54 PM ˘ ` 2 mac001 1200DPI 90LPI
