736211
19
Verklein
Vergroot
Pagina terug
1/76
Pagina verder
23GB/IE
Danger!
Handle damaged or leaking batteries with
extreme caution and dispose of them properly
as soon as possible. Wear gloves when doing
so.
If you come into contact with battery acid, wash
the affected area with soap and water. If battery
acid gets in your eye, rinse it with water and
seek medical attention immediately!
The connection terminals must not be short-circuit-
ed.
Replacing the batteries
CAUTION! Observe the following instruc-
tions to avoid mechanical and electrical
damage.
Danger!
There is a battery LR03 in the item. You can replace
the battery if it stops working.
1. Raise the display on the side, and carefully re-
move it. The battery is at the back of the display.
2. Slide the battery carefully out of the battery
casing and replace with a new one.
Note: Make sure that the battery is inserted prop-
erly and completely in its casing.
3. Insert the display and the cable connections into
the casing once again.
Note: Make sure that the display is correctly
inserted in the casing once again.
Assembling the stepper
Step 1:
Insert both plastic feet into the pipe on the back of
the frame. The ribbed contact surfaces lie on the
floor and the sharp ends point backward (Fig. C).
To anchor it, a self-tapping screw is inserted into the
pre-drilled hole on the underside of the frame.
Note: Make sure that the pre-drilled hole in the
frame and the plastic foot are placed exactly on
top of each other.
Step 2:
The adjustable screw is screwed into the thread on
the front of the stepper.
With the help of this screw, you may adjust the step
height of the tread surfaces.
To increase the step height, turn the adjustable
screw in a clockwise direction. To lower the step
height, turn the adjustable screw in an anticlock-
wise direction.
Step 3:
Remove the computer from the stepper by pulling
it upwards.
Place the supplied battery in its appropriate com-
partment on the underside of the computer. Ensure
that the polarities are correctly aligned.
Connect the computer to the connector on the
casing and insert it once again. Make sure that the
cable does not get pinched during this procedure.
Step 4:
Observe the maximum stretch length of
the straps.
The shorter the straps, the greater the effort expend-
ed.
Shorten the straps by locking the rubber hose
with the safety ball into place (Fig. B).
IMPORTANT! Make sure not to shorten
the straps too far. Do not go past the
“MIN.” marking!
Hook the metal hook into the eyelet on the step-
per frame and screw in the fastener on the hook
tightly (Fig. D).
Important! Before training, check that
the straps are securely fitted, and that
the hook is safely and tightly screwed
in. Caution! The eyelets are secured for
tensile loads upwards only, and may not
be subjected to transverse loads. There is
a risk of injury, or damage to the stepper.
When you are not training with the straps, unhook
them from the eyelets to avoid tripping over them.
Check whether all screws and nuts are securely
tightened.
Operating the computer
The stepper meets accuracy grade C, i.e., there is
no claim to accuracy in the computer displays.
Turning the item on and off
When you start exercising or operating the pedals,
the computer switches on automatically. If the
stepper is out of operation for approx. 4 minutes,
the computer switches off automatically.
19

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Crivit IAN 304198 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Crivit IAN 304198 in de taal/talen: Nederlands, Duits, Engels, Frans, Portugees, Spaans als bijlage per email.

De handleiding is 2,64 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info