517196
16
Verklein
Vergroot
Pagina terug
1/48
Pagina verder
16
Step 5:
Installation of the leg curler (10), the round pad holders (19) and the
round pads (20) on the front foot (8) with the sliding bearing (25), the
shaft piece (44) and the Allen screw (55).
1. Insert two sliding bearings (25) in the middle of the leg curler (10). Insert
the leg curler in the holder of the foot (8). Align the holes in the holder
and the sliding bearings. Push the shaft piece (44) through from one
side. From the opposite side, screw the screw (45) into the threaded
hole of the shaft piece and tighten fi rmly.
(Note: After installation, the holder of the foot (8) must not be bent and
the leg curler must move easily.)
2. Push the two round padding holders (19) centrally into the correspon-
ding holes of the leg curler (10). Push on a round pad (20+20a) from
each side.
3. Finally, push a spring circlip 1 (27) on the bar bell weight holders of the
leg curler (10).
Step 4:
Installation of the butterfl y arms (5) incl. the left and right handgrips (6)
and (7) on the rear feet (1) with the hexagonal screws (43), the carriage
bolts (42), the sliding bearing (25), the washers (52), spacer nut (37), the
handgrip nut (85) and the self-locking nuts (49).
1. Place the parts named above near the feet (1). Insert two sliding
bearings (25) in the middle of the butterfl y arm (5). Put a washer (52)
on a screw (43), push the screw through the bearings and screw on a
nut (37) from the back.
(Note: Tighten the nut (37) only suffi ciently to allow the screw (38) to
be easily turned.)
2. Push the end of screw (43) through the corresponding hole in the right
foot (1). Put on a washer (52), screw on a the handgrip nut (65) and
tighten fi rmly.
(Note: The butterfl y arm (5) must move easily after installation.)
3. Insert two sliding bearings (25) in the upper end of the butterfl y arm
(5). Align the holes in the U-section of the handgrip (7) with the holes in
the sliding bearings (25), push through the screw (42) and fasten with
the washers (52) and the nuts (49).
(Note: The end of the handgrip (7) must point forwards after installation.
The line of sight is specifi ed as viewed seated on the machine during
training.)
4. Install the second butterfl y arm (5) and the handgrip (6) at the left side
on foot 1 as described in 1. To 3.
5. Finally, push a spring circlip 1 (27) on the bar bell weight holders of the
butterfl y arms.
16

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Christopeit Basic-Concept 9881 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Christopeit Basic-Concept 9881 in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 0,9 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info