Check the rinse aid level
Mechanical indicator C.
Electrical indicator light on control panel (if present).
Check the
salt level
On models with water softener
system only.
Mechanical indicator D.
Electrical indicator light on control
panel (if present).
Load the racks
Refer to the dishwasher loading instructions.
Select a programme
Press the button until the desired programme lights up.
Select the required
options
If necessary (where present). The corresponding indicator light
illuminates/the display shows the relevant information.
Turn on the water tap,
then close the door to
start the programme
“Cancel”
• Open the door, press until the
indicator lights 4 + 5 (marked by
“end” on the control panel) light
up.
• Close the door, after about 1
min. the cycle ends.
“Change programme in
progress”
• Open the door.
• Select another programme and
close the door in order to start
the new cycle. End-of-cycle.
Wash cycle
- Only open the door if necessary
(Warning: steam may escape).
- If the appliance is switched off
during a wash cycle, when
switched on again it will resume
the cycle from the point where it
was interrupted.
Switch off the appliance.
At the end of the programme the dishwasher emits a brief audible signal.
Indicator lights 4 + 5 (marked by “end” on the control panel) illuminate.
Open the door and press the On/Off button.
All indicator lights switch off.
Turn off the water tap,
unload the dishes
from the racks
Warning: be careful opening the door, as steam will escape!
Empty the dishwasher starting from the lower rack.
NLFGBD
GB
HOW TO USE THE APPLIANCE
