GBD NLF
Before using the dishwasher, you are advised to read the user instructions!
On/Off button
Press the button to switch on the
dishwasher. The indicator light for the last
programme to be selected lights up; at the
end of the cycle the dishwasher emits a
brief audible signal.
Programme selection button
Press this button to select the desired
programme.
The indicator light of the selected
programme illuminates.
Indicator lights
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Add rinse aid
Options
Half load
selector button
Press this button to select the half load
option; the corresponding indicator light
will illuminate. Press the button again to
the deselect the option; the corresponding
indicator light will go out.
The half load function is suitable for
smaller wash loads. The dishes should be
distributed over both racks.
Antibacterial rinse
(Sani Rinse option)
This function adds an antibacterial rinse at
the end of the wash cycle, guaranteeing a
further reduction of bacteria. The indicator
light illuminates when the function is
activated.
If the temperature is not maintained at a
constant level during the antibacterial rinse
programme (e.g. if the door is opened or
there is a power cut), the programme
indicator lights will flash to signal that the
sanitizing effect of the antibacterial rinse is
not guaranteed.
“Delayed start” button
The wash cycle can be programmed to
start after 1-12 hours. The delayed start
can be programmed either before or after
selecting the desired wash programme.
When the door is closed, a pre-wash cycle
is run, after which the delayed start
countdown begins.
Quick Wash
This option, when selected together with
any wash programme (except pre-rinse )
SHORTENS THE DURATION of the
selected wash cycle from a minimum of
10% to a maximum of 55%, depending on
the programme selected.
This function is activated by pressing the
QUICK WASH button after having
selected the desired programme.
Tablets selector
This setting allows you to optimize the
wash cycle in accordance with the type of
detergent used. If you use combined
detergents that combine detergent, rinse
aid and/or salt in 1 tablet
Press the «Antibacterial rinse» + «Quick
Wash» buttons simultaneously (the
«Tablet» indicator light will illuminate). If
you are using a powder or liquid
detergent, the «Tablet» indicator on the
control panel must be off.
QUICK REFERENCE GUIDE
GB
