9
supply of air into the room. When the cooker hood is used in conjunction with other
appliances supplied with energy other than electric, the negative pressure in the room
must not exceed 0,04 mbar to prevent fumes being drawn back into the room by the
cooker hood.
4 - INSTALLATION.
Follow the instructions given below for easy installation:
4.1 - Fixing the canopy hood
4.2 - Electrical connection and working test
4.3 - Ducting or Recirculation fitting
4.4 - Fitting the telescopic chimney stack
4.1 - Fixing the wall brackets. Splashback.
1 - Drilling the wall:
a) Draw a vertical line on the wall at the point in which the hood is to be installed. This line must
be at a distance d from the cooker top of:
- without splashback (fig. 2a): d=972 mm min.
- with splashback (optional) (fig. 2b): d=322+H mm, where H= height in mm of the visible part of
the splashback.
b) On the horizontal line, mark the centres of the two holes to be drilled, at a distance of 378 mm
to the right and to the left of the centre of the hood (fig. 2a-b).
c) Using a Ø␣ 8 mm drill bit, drill the holes marked, and insert the plugs provided. Screw the ring
screws provided in the accessories all the way into he holes.
2 - Splashback (optional).
In this case, the height of the hood above the cooker is determined by the height of the
splashback B and by any raised back on the worktops. The splashback must be fitted before fitting
the hood canopy, and if it is to be fixed to the wall both at the top and bottom it must be fitted at
the right height before fitting the base units, or at least before fitting the worktop. As this is a
complicated operation, it should be carried out by the technician responsible for installing the
kitchen, or by competent persons with knowledge of the final dimensions of units. To fix the top
only, proceed as follows:
a) Rest the splashback on the worktop as shown in (fig. 2a), bring it into contact with the wall and
centre it on the base.
b) Mark the centres of the two holes in the upper fold.
c) Drill the wall using a Ø␣ 8 mm drill bit, and fix the splashback using the Ø 8 mm plugs and the
screws provided.
d) Any stabilisation of the bottom, if required, will be dealt with by the installer.
3 - Adjusting and fixing the hood (fig. 3).
The hood is supplied with two adjustable hooks at the back;
a) Hook the hood to the rings.
b) Remove the metal grease filters, in order to access the adjustable hooks from the inside of the
hood.
c) Adjust the hood vertically and horizontally by turning the screws V2.
d) Lock the hood against the wall by turning the screws V1 in a clockwise direction.
