541685
12
Verklein
Vergroot
Pagina terug
1/19
Pagina verder
Fabrikant – Hersteller – Manufacturer – Fabrikant: ANSSEMS AANHANGWAGENS B.V. www.anssems.eu
Versie: AMT-1
12
- whether the ramps are at right angles with respect to the rear of the trailer. If not,
the proper positioning cannot be guaranteed.
-
Check whether the ramp is fully on the front tip. If not, the ramp may be lifted out of
its location when vehicles drive up the ramp. This will lead to a hazardous situation.
-
Check whether the hook is touching the vertical edge on the back of the trailer. Dirt
in the channel may lead to an incorrect ramp placement.
-
check whether the ramps are at the correct distance from each other. Keep in mind
the track size of the vehicle being driven up.
- check whether the maximum permissible load is being exceeded.
- check whether there is visible damage on the ramps
-
check that there are no persons in the vicinity of the vehicle being driven up or
down. This would be hazardous. They may be injured in case of an unexpected
situation that may arise if a vehicle does not drive up or down properly.
-
check whether the ramps are free of dirt, ice and snow.
-
check whether you are conforming to the applicable laws and regulations when on
public roads. If the lighting fittings are no longer visible, you should take appropriate
measures (for example, use the warning triangle). ATTENTION: Ensure that you
are visible during loading/unloading on public roads. This is for your safety and that of other road users.
-
Check whether the parking jacks have the right hight and if the clamps are sufficient fastend.
- Set the hight from the parking jacks that (advice is ca. 7 à 8 cm (see measure "X" in the picture) loose from the ground, depending
the load, coupled hight of the trailer, ...) that the clamps of the parking jacks, after charging the trailer do not have to be unscrewed
when the trailer is loaded. An unsave situation can occure and cause perminante dammage to the trailer. The best situation is
when the trailer is loaded and the parking jack is loose from the ground.
The ramps should be checked at least once a year by duly trained
personnel in authorised workshops or service centres.
- ATTENTION: When the back from the trailer moves down, the hook can become so tiny that when vihicles are droven onto the
trailer with a wheelbase bigger than the lenght of the ramp, the hook can lift. This happens when the ramp is not completly on the
nose. When the hook is pushed to the point, the hook can land at the side. The situation is not save like this. The ramp can even
fall on the floor.
correct
12

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Anssems AMT bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Anssems AMT in de taal/talen: Engels als bijlage per email.

De handleiding is 5,58 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Anssems AMT

Anssems AMT Gebruiksaanwijzing - Nederlands - 18 pagina's

Anssems AMT Gebruiksaanwijzing - Deutsch - 18 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info