[5] CLX-CodeLoxx: Installation Operation Manual: V01 - (Art.-No. 800050)
General operation with media
1. ABUS chip key (ACS)
To operate, the ABUS chip key is inserted into the reader module (reading slot on the outer
knob) and taken out again.
The ABUS chip key is reversible; the plug-in direction is variable.
Important: Operation approval only occurs after the key has been removed.
2. Proximity / Hitag1 / Hitag2 transponder:
To operate using a Proximity / Hitag1 / Hitag2 transponder, touch the centre of the reading
module with the transponder. During programming: Place the transponder on the reading
module on the outer knob.
A rapidly blinking green light confirms the reading of a valid locking medium. The locking
medium must be removed from the reading module (at least 100 mm distance) before
further reading can be started. During the coupled period no other reading with a locking
medium is possible.
Throughout the operating instructions, the insertion and removal of the chip key - as well as the
presentation and removal of the transponder - is indicated by the word “present”.
Every input of a valid locking medium produces an approval for 6 or 12 seconds: during this time
the door can be unlocked and opened. The system then goes back to the free-running state.
For further functions you require a recording system, the transfer device and the
SKM software:
Recording function, setting the time,
Defining time limitations,
Automated changeover to summer/winter time
Time-controlled activation/deactivation of permanent access (ZAAP)
