607219
70
Verklein
Vergroot
Pagina terug
1/150
Pagina verder
Chapter 4 Create Secure Connections Across the Internet
ZyWALL USG 20-2000 User’s Guide
70
4.1.3 What Can Go Wrong
If the IPSec tunnel does not build properly, the problem is likely a configuration error at one of the
IPSec routers. Log into both IPSec routers and check the settings in each field methodically and
slowly. Make sure both the ZyWALL and remote IPSec router have the same security settings for
the VPN tunnel. It may help to display the settings for both routers side-by-side.
Here are some general suggestions.
The system log can often help to identify a configuration problem.
If you enable NAT traversal, the remote IPSec device must also have NAT traversal enabled.
Both routers must use the same authentication method to establish the IKE SA.
Both routers must use the same negotiation mode, encryption algorithm, authentication
algorithm, and DH key group.
When using manual keys, both routers must use the same encryption key and authentication
key.
When using pre-shared keys, both routers must use the same pre-shared key.
The ZyWALL’s local and peer ID type and content must match the remote IPSec router’s peer and
local ID type and content, respectively.
Both routers must use the same active protocol, encapsulation, and SPI.
If the sites are/were previously connected using a leased line or ISDN router, physically
disconnect these devices from the network before testing your new VPN connection. The old
route may have been learnt by RIP and would take priority over the new VPN connection.
To test whether or not a tunnel is working, ping from a computer at one site to a computer at the
other.
Before doing so, ensure that both computers have Internet access (via the IPSec routers).
It is also helpful to have a way to look at the packets that are being sent and received by the
ZyWALL and remote IPSec router (for example, by using a packet analyzer such as Wireshark).
Check the configuration for the following ZyWALL features.
Make sure the To-ZyWALL firewall rules allow IPSec VPN traffic to the ZyWALL. IKE uses UDP port
500, AH uses IP protocol 51, and ESP uses IP protocol 50.
The ZyWALL supports UDP port 500 and UDP port 4500 for NAT traversal. If you enable this,
make sure the To-ZyWALL firewall rules allow UDP port 4500 too.
Make sure regular firewall rules allow traffic between the VPN tunnel and the rest of the network.
Regular firewall rules check packets the ZyWALL sends before the ZyWALL encrypts them and
check packets the ZyWALL receives after the ZyWALL decrypts them. This depends on the zone
to which you assign the VPN tunnel and the zone from which and to which traffic may be routed.
If you set up a VPN tunnel across the Internet, make sure your ISP supports AH or ESP
(whichever you are using).
If you have the ZyWALL and remote IPSec router use certificates to authenticate each other, You
must set up the certificates for the ZyWALL and remote IPSec router first and make sure they
trust each other’s certificates. If the ZyWALL’s certificate is self-signed, import it into the remote
IPsec router. If it is signed by a CA, make sure the remote IPsec router trusts that CA. The
ZyWALL uses one of its Trusted Certificates to authenticate the remote IPSec router’s
certificate. The trusted certificate can be the remote IPSec router’s self-signed certificate or that
of a trusted CA that signed the remote IPSec router’s certificate.
Multiple SAs connecting through a secure gateway must have the same negotiation mode.
70

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw ZyXEL ZyWALL USG 20 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van ZyXEL ZyWALL USG 20 in de taal/talen: Engels als bijlage per email.

De handleiding is 7,47 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van ZyXEL ZyWALL USG 20

ZyXEL ZyWALL USG 20 Snelstart handleiding - Deutsch, English, Français, Italiano, Espanõl, Svenska - 2 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info