Here's how to turn on the power of the MRS-1044 and your
other equipment.
1.
Make sure that the AC adaptor, instruments, and
audio system (or stereo headphones) are connected
appropriately to the MRS-1044. (For details on
connections, refer to ➔ p.14.)
2.
Press the rear panel [POWER] switch to turn on the
power of the MRS-1044.
If electronic instruments are connected to the [INPUT 1]/
[INPUT 2] jacks, turn on the power in the order of the
electronic instruments → MRS-1044.
3.
Turn on the power of the audio system connected
to the [MASTER] jacks.
The internal hard disk of the MRS-1044 contains several
demo songs. Here's how to load a demo song from the hard
disk.
1.
Press the [PROJECT/UTILITY] key.
The display will indicate "PROJECT."
On the MRS-1044, data for a song (including the demo
songs) is managed in units called "projects." When you
load a project, the complete state in which that song was
saved will be reproduced.
2.
Press the [ENTER] key.
The display will indicate "PROJECT SELECT."
3.
Press the [ENTER] key once again.
Now you can select from the projects that are saved on the
internal hard disk.
4.
Turn the dial to select a demo song project.
Project numbers 992 and following are not demo songs;
they are projects that contain material for use with the
"Introductory tour" that starts on page 17, or projects from
which you can import rhythm patterns.
5.
Press the [ENTER] key.
The selected project will be loaded.
After the demo song has finished loading, here's how to
play it back.
1.
Turn down the volume of your audio system.
If you are listening through headphones connected to the
[OUTPUT] (PHONES) jack, turn down the knob located
beside the jack.
2.
Press the transport section PLAY [
R
] key.
The demo song will begin playing.
3.
Raise the volume of your audio system (or the knob
for the [OUTPUT] (PHONES) jack) to a comfortable
volume.
Play back the demo song
