644523
22
Verklein
Vergroot
Pagina terug
1/52
Pagina verder
22
Controlling the belt tension.
2.4.2 Working area
The right humidity in the ground is very
important for right tamping. Water is use
as a lubricant to help that the earth parti-
cles are pushed together.
Too less humidity causes not enough
tamping.
Too much humidity causes gaps which
are filled with water.
The machine may not be used on hard,
frozen or mixed earth that contains
scraps of bricks.
Too high watering or excessive water
contents can cause a stalling of the ma-
chine.
2.4.3 Starting
Turn on the ignition (Fig. B) by turning it
onto the position ON.
Set the petrol cock 13 (Fig. C) onto the
position ON (right).
Turn the Choke 12 (Fig. C) onto the posi-
tion OPEN (left).
IM PORT AN T
When the choke stands on the
closed position, the fuel mixture
gets concentrated for starting of
the cold engine. The position
OPEN produces the right fuel mix-
ture for the usual operation after
starting and for starting the ma-
chine when the engine is hot.
Adjust the throttle control 11 (Fig. D) at
half throttle.
Grab the starting handle (Fig. E) and
start moving it slowly. At one position the
resistance gets very hard. Let the cable
rewind a bit and pull on it powerfully.
ATTENTION:
NEVER pull the cable till the end of it.
NEVER skip the cable after pushing on it.
Let it rewind.
Start the engine with the starting handle.
Let the plate compactor running warm for
about 2 minutes at half throttle.
Set the wished engine speed with the
throttle control and start working.
2.4.4 Stopping
Turn back the throttle control to idling
mixture
Turn off the ignition
Close the petrol cock.
Before storing the machine it must get
cold.
2.4.5 Operation instructions
Operate the machine by postponing the
handle sidewise.
Always hold a good stand do that you
can’t slide or lose the control of the ma-
chine.
When the machine has an optional water
tank you can adjust the flowing speed by
using the cock in the tube.
One meter around the machine and into
the working direction there mustn’t be
any person except of the operator.
During tamping and raising of an earth
building you have to tamp about 100 to
150 mm inside the edge two or three
times. Then you can tamp the edge.
When tamping earth in the middle of a
building the plate shouldn’t touch the re-
inforced concrete piles, the underground
construction the ground of the machine
and the underground pipes.
During workings in the inside of a build-
ing the plate and the eccentric block
mustn’t strike the walls.
When lots of machines work together, the
distance between the front machine and
the machine that is behind it should be at
least 10 m. The parallel distance
shouldn’t be less than 5 m.
When the machine works on soft or rough
ground you have to decrease the engine
speed by using the throttle control so
that the machine doesn’t sink. When
there is a descent you have to take care
that the plate compactor doesn’t faint.
You have to take care extremely in the
following dangerous areas:
At tunnel workings you have to cater
for a good ventilation to avoid acci-
dents. There must be a functioning
control system for the supply of fresh
air.
Near landlines there’s a high danger
of electrical shocks. Only the opera-
22

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Zipper ZI-RPE60 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Zipper ZI-RPE60 in de taal/talen: Duits, Engels, Frans, Spaans als bijlage per email.

De handleiding is 1,61 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info