Handleiding Zelmer ZPG6004SZ (pagina 24 van 28) (Engels, Pools)

540053

Verklein

Vergroot

Pagina terug

1/28

Pagina verder

PG-005_v01

Operating the hob

LIGHTING

Turn the appropriate knob left to position . Press it all the

way in. After the burner is lit, hold the knob pressed in for

approx. 10 seconds.

If after approx. 15 seconds of holding the knob pressed

in the

position the burner is not lit, wait at least one

minute and try again. If after a few attempts the burner

still cannot be lit, check if the burner crown and the cap

are put on correctly.

If the ﬂ ame of the burner is accidentally put out, turn the

burner off by turning the knob to position , and wait

one minute before turning the burner on again.

To put out the ﬂ ame, turn the knob to the position.

When you are not using the hob, make sure that the

knobs are in the closed position

USING THE APPLIANCE

Before ﬁ rst use, remove all packaging material

and protective ﬁ lm from the hob.

For maximum efﬁ ciency and best gas consumption, follow

the recommendations below:

use cookware with a ﬂ at bottom and a diameter ●

appropriate for a given burner, see table below:

BURNER COOKWARE DIAMETER

LARGE

∅ 180-260 mm

MEDIUM

∅ 120-220 mm

SMALL

∅ 80-160 mm

after reaching the boiling temperature, set the knob to ●

the minimum position .

during cooking, always cover the dish with a lid. This ●

prevents excessive vapour from accumulating in the room.

If you use cookware with diameter lower than

●

recommended, the ﬂ ame will go around the sides of the

dish causing the handles to overheat and in some cases

to burn.

Overheated fats and oils may easily catch

ﬁ re. Therefore, dishes prepared with fat or oil

should only be cooked under supervision.

In the case of power shortage, burners can be ignited

●

using a gas lighter or matches. Take extra care when

igniting burners with a gas lighter or matches.

Do not put a dish on two burners at the same time.

●

Use only clean, dry cookware with a height of approx.

●

2/3 of its diameter.

Never operate the hob with wet hands.

●

Never leave the appliance unattended with gas burners

●

turned on.

Cleaning and maintenance

Before proceeding with cleaning, disconnect

the hob from the power supply.

In order to look nice and work properly the hob should be

systematically cleaned.

Before cleaning, remove pan supports and external

●

burner elements from the hob.

Hob surface, enamelled surfaces and burner casings

●

should be cleaned using a damp cloth soaked in warm

water with a washing-up liquid. Avoid using too much

water.

Strong dirt may be removed using special detergents for

●

cleaning ceramic hobs and stainless steel.

Do not use any coarse-grained abrasive agents, sharp

●

objects, wire sponges, powders and/or aggressive

chemicals for cleaning the hob and knobs.

Residues of food can best be removed by using

●

a wooden spatula or a special scrapper, while being

careful not to scratch the hob surface.

Molten sugar, aluminium and plastics should be removed

●

immediately (when warm) from the surface of the hob.

Sugar melts quickly on hot surfaces and may result in

permanent stains.

When cleaning, do not let water get under the hob.

●

Place dirty pan supports in warm water with a detergent,

●

then wash and dry them.

CLEANING THE BURNERS

In the case of food spillage, and periodically, remove tarnish

and dirt from the gas burners, ignitors and ﬂ ame failure

safety devices.

Start cleaning burners by taking off the burner crowns and

the burner caps.

Put the burner crowns and caps in warm water with

●

a detergent, then wash and dry them.

Use a steel wire to unclog the holes in the burner crown.

●

After washing, check if the ﬂ ame holes are clear.

Make sure that the burner base near the nozzles is

●

always kept clean. Dirty nozzles may cause clogging and

the burner’s ﬂ ame will be weak, or will not light at all.

The nozzles should be cleaned by brushing them with

●

a brush soaked in a solvent.

Cleaned elements should be dried thoroughly, as wet

●

elements may prevent the gas from being ignited, or may

cause its incorrect burning.

Replace the dried elements, being careful not to damage

●

any of the ignitors or ﬂ ame failure safety devices.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Zelmer ZPG6004SZ Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info