694510
22
Verklein
Vergroot
Pagina terug
1/72
Pagina verder
22
GB
Press button (2) continuously to lower the ames and to switch o the burner (putting the re out: STAND BY”). Press button
(2) briey to gradually lower the ames.
Press button (1) to increase the ame height. Briey press button (1) to gradually increase the ames.
Simultaneously press button (4) and button (2) to turn o the rear burner.
Simultaneously press button (4) and button (1) to turn on the rear burner again.
It is not possible to have only the rear burner be lit.
Switching o the appliance
Press button (2) to lower the ames and to switch o the burner.
Then press “OFF button (3) to switch o the entire unit, including the pilot ame.
If the appliance is not used for a longer period it is advisable that you turn o the gas valve in the gas pipe.
Important: if the pilot ame has gone out for whatever reason, you must wait at least 5 MINUTES before lighting
the pilot ame again.
Gas saving electronics
The electronics in your gas re are programmed to save gas when the appliance is not in use. If the receiver doesn’t receive
a signal from the remote every 3 hours it will switch to the pilot ame. After 5 days it will shut down the gas re completely.
You can prevent this from happening by programming the timer on the remote. By doing this a signal will be send regularly
to the receiver.
Failure
If it looks as if the signals of the remote control are not properly received by the stove (receiver), it may be caused by:
Empty batteries: change the batteries.
An electric problem: solve by carrying out a hard reset. To do so, you must disconnect the receiver from its power source by
removing the batteries or disconnecting the adapter. Then press the “RESET button on the receiver for 8 seconds. Power the
receiver up again and restart the gas re.
If the appliance often switches o you should contact your installer.
Operation (remote control with EcoWave)
For the complete explanation of the operation via the SYMAX-remote control, please refer to the instruction manual supplied
separately.
Operation (optional Wanders EcoWave app)
It is possible to order the optional Wi-Fi module in order to operate the replace using the Wanders EcoWave app,
The app can be downloaded for free at the Apple App Store and/or the Google Play Store. Incidentally, the app can only be
used in combination with the SYMAX EcoWave remote control.
Control (manual control)
In the event of empty batteries or a defective receiver, the heater can also be operated manually. To do so, the piezo ignition
cable must rst be disconnected from the receiver, before connecting it carefully to the piezo connector (10) on the gas
control unit.
Lighting the re and putting it out
1. Open the gas stopcock which is mounted in the gas pipe leading to the appliance.
2. Press “O I switch (5) on the gas control block in the I position.
3. Turn motor switch (7) on the gas control block all the way to the right. The switch will make a ticking sound.
4. Turn operating switch (6) on the gas control block in the MAN position; an orice (8) becomes visible.
5. Push the metal pin in the orice with something like a small pen. The gas will now ow to the pilot.
6. While keeping the metal pin pressed in, press the (square) ignition fuse (9) (next to the O I switch) to ignite the pilot
22

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Wanders Larix bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Wanders Larix in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 6,12 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info