09 Maintenance and specifications
Replacing bulbs
09
}}
357
Headlight housing
The entire headlight housing must be lifted
out when replacing all front bulbs.
Removing the headlight housing
Pull out the headlight housing's locking
pins.
Remove the headlight housing by alterna-
tively pulling the front and rear edges until
it can be lifted out.
CAUTION
When disconnecting the connector, pull on
the connector itself and not on the wiring.
Unplug the wiring connector by holding
down the clip with your thumb.
Pull the connector out with the other
hand.
5. Lift out the headlight housing and place it
on a soft surface to avoid scratching the
lens.
6. Replace the defective bulb(s).
Reinserting the headlight housing
1. Plug in the connector until it clicks into
place.
2. Reinstall the headlight housing and lock-
ing pins. The short locking pin should be
closest to the grille. Check that they are
correctly inserted.
The headlight housing must be properly
in place and the wiring connector cor-
rectly reconnected before the lighting is
switched on or the remote key is inserted
into the ignition slot.
3. Check that the lights function properly.
Removing the cover to access the
bulbs