738292
6
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
Legal notice
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent
the technical status at the time of printing.
© Copyright 2016 by Conrad Electronic SE.
G
TROUBLESHOOTING
In purchasing the multimeter, you have acquired a product which has been designed to
the state of the art and is operationally reliable.
Nevertheless, problems or faults may occur. Therefore, we would like to describe here
how you can solve any problems. Always observe the safety instructions!
Error Possible cause
No resistance measurement possible.
Is the battery dead?
Check the state of the battery and, if necessary, the fuse.
No measurement possible.
Is the fuse defective?
Check the fuse (fuse replacement).
No change in measured value.
Is the right measuring range and measuring mode selected
(AC/DC)?
Incorrect measurement values are
displayed.
Did you zero the display or carry out a 0-Ohm calibration for
resistance measurement before beginning the measure-
ment?
Repairs other than described above are to be carried out exclusively by an authorised special-
ist.
If you have questions concerning the use of the meter, please contact our technical support
team.
TECHNICAL DATA
Max. measuring voltage 300 V
Input resistance for V range
DC: approx.10 kΩ/V
AC: approx. 4.5 kΩ/V
Power supply 1 Mignon battery 1.5 V (AA, UM3, LR6, etc.)
Operating conditions 0 °C to +40 °C, <75% relative humidity, not condensing
Storage temperature -10 °C to +50 °C, <80% relative humidity, not condensing
Measurement category CAT III 300 V
Pollution degree 2
Operating altitude max. 2000 m above sea level
Protection class 2
Weight approx. 120 g
Dimensions (L x W x H) 116 x 68 x 34 mm
Length of the measuring cable approx. 650 mm
Measurement tolerances
Specication of the precision in ± (% of the scale value). The precision is valid for one year at a tempera-
ture of +23 °C ± 2 °C, and at a relative humidity of less than 60%, non-condensing.
Direct voltage range
Range Precision Note
2,5 V / 10 V / 50 V / 250 V / 300 V ±4% Internal resistance 10 kΩ / V
Alternating voltage range (50/60 Hz)
Range Precision Note
10 V / 50 V / 250 V / 300 V ±5% Internal resistance 4.5 kΩ / V
Direct current range
Range Precision Note
10 mA / 250 mA ±4%
F500mA H 500V fast-blowing
6.3 x 32 mm, ceramic
Resistance range
Range Precision Note
X10 / x1k ±4%
Measurement voltage: -1.5 V
Measurement current (x10): approx. 15 mA
Measurement current (x1k): approx. 0.15 mA
Battery test
Range Accuracy Note
1.5 V / 9 V not specied
Attenuation measurement dBm
Range Accuracy Note
-20 dBm to +22 dBm not specied
10 V/AC measurement range
0 dB = 1 mW / 600 Ω (0.775 V)
Do not exceed the maximum permitted input values under any circumstances. Never
touch circuits or parts of circuits when they may contain voltages greater than 33 V/
ACrms or 70 V/DC! Risk of fatal injury!
Cleaning
Always observe the following safety instructions before cleaning the device:
Live components may be exposed if the covers are opened or parts are removed, unless
this can be done manually without tools.
Before cleaning or repairing of the device, all the cables have to be detached and the
device must be turned off.
Do not use any scouring cleansers, petrol, alcohol or the like to clean the product. These could corrode the
surface of the measuring instrument. Furthermore, the fumes are explosive and hazardous to your health.
Moreover, you should not use sharp-edged tools, screwdrivers, metal brushes or similar implements for
cleaning.
To clean the device, the display or the measurement lines, use a clean, dry, lint-free anti-static cleaning
cloth.
Inserting/changing the batteries
To use the measuring instrument in the resistance range, a Mignon (AA) type battery, included in the
package, is required.
Insert a new battery:
when using for the rst time,
when a 0-Ohm adjustment in the resistance measuring range can no longer be performed.
To insert/replace the battery, proceed as follows:
Remove all the measuring leads from the device and turn the multimeter off.
Loosen the screw on the rear of the battery compartment and carefully remove the cover (7) of the bat-
tery compartment by pulling it backwards.
Now place a new battery into the battery compartment, observing the correct polarity. Look for the polar-
ity signs in the battery tray.
Now, close the cover carefully again.
Never operate the meter when it is open. ! RISK OF FATAL INJURY!
Do not leave at batteries in the device. Even batteries that are leak-proof can corrode
and thus release chemicals that could be detrimental to your health or damage the
device.
Leaking or damaged batteries might cause severe burns if they come into contact with
the skin. Therefore, use suitable protective gloves.
Remove the battery if the device is not to be used for a long time, to prevent leaking.
Do not leave batteries lying around carelessly. They could be swallowed by children or
pets. If swallowed, consult a doctor immediately.
Make sure that the batteries are not short-circuited. Do not throw batteries into a re.
Batteries may not be recharged. There is risk of explosion.
You can order suitable alkaline batteries by stating the following order no.:
Order no. 652501 (please order 1x).
CHANGING THE FUSE
Always adhere carefully to the safety instructions when replacing the fuse!
Make sure that only fuses of the type stated and of the rated current specied are used
as a replacement. The use of incorrect or repaired fuses or a bypassing of the fuse
holder is not permitted and can lead to a re or to an arc explosion.
The measuring input is protected against overload. If you can no longer carry out measurements, you have
to replace the internal high-performance fuse.
Proceed as follows to change the fuse:
Remove all measuring leads and turn the multimeter off.
Loosen the screw on the rear of the housing and carefully remove the cover (7) of the battery compart-
ment by pulling it backwards.
Replace the high-performance fuse with a new fuse of the same type and current strength.
Ceramic F500mA H 500 V fast blowing 6.3 x 32 mm.
Now, close the cover carefully again.
DISPOSAL
Electronic products are recyclable material and do not belong in the household waste. Dispose
of an unserviceable product in accordance with the relevant statutory regulations.
Remove the inserted battery and dispose of them separately from the product.
DISPOSAL OF USED BATTERIES/RECHARGEABLE BATTERIES!
As the end user, you are required by law (Battery Regulation) to return used batteries. Do not dispose of
used batteries in the household waste!
Batteries/rechargeable batteries containing harmful substances are marked with the following
symbols, they point out that they are not allowed to be disposed of in the household waste. The
symbols of the relevant heavy metals are: Cd = cadmium, Hg = mercury, Pb = lead (the marking
can be seen on the battery, e.g. underneath the refuse bin symbol shown on the left). You can
return your used batteries/rechargeable batteries free of charge at the ofcial collection points of
your community, in our stores, or at places where batteries or rechargeable batteries are sold!
You thereby full your statutory obligations and contribute to the protection of the environment!
6

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Voltcraft VC-13A bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Voltcraft VC-13A in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 1,93 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info