667318
45
Verklein
Vergroot
Pagina terug
1/234
Pagina verder
43
DEFRNLITESPTPLHURU EN
0478 111 9925 B - EN
In order to prevent injuries or damage to
the machine, ensure that you are familiar
with operation of the BBC system prior to
initial use.
Two-hand operation:
The mowing blade can only be engaged as
follows with the engine running:
Press blade stop lever (1) towards the
handlebar and hold, then pull blade clutch
lever (2) upwards with the other hand and
allow it to engage.
Avoid overloading of the blade brake
clutch
An overload can occur
if mowing is continued when the grass
catcher bag is full.
if the mowing channel is blocked.
if mowing at excessive speed in high
grass.
If the mowing blade is blocked, the grass is
no longer cut and the engine cuts out.
For this reason, never mow when the
mowing channel is blocked or the grass
catcher bag is full; adapt the driving speed
to the conditions. Use a mulching kit
(special accessory) if necessary.
Completion of work
Upon completing work, always remove
combustible material (grass, leaves, etc.)
from the housing and engine to prevent a
fire hazard.
A perfect, thick lawn is achieved by
Mowing at low driving speeds.
Mowing regularly and keeping the grass
short.
Not cutting the lawn too short in hot, dry
conditions as it will be burnt by the sun
and become unsightly.
Using a sharp mowing blade – mowing
blade should therefore be sharpened
regularly (specialist dealer).
Changing the cutting direction regularly.
10.1 Starting the engine
Check the oil and fuel levels.
(Ö 7.5)
Open tank ventilation screw (1) and fuel
cock (2).
Set throttle lever (3) to the
Choke position (4) when the
engine is cold.
Set throttle lever (3) to the Start
position (5) when the engine is
warm or during hot weather.
Pull recoil starter rope (6) slowly to the
point of compression resistance and
then pull vigorously to arm's length to
prevent kickback.
Slowly release the cable so that it can
gradually be rolled up by the starter.
Repeat the starting procedure until the
engine starts.
Set throttle lever (3) to the Start
position (5).
10.2 Engaging the mowing blade
1 Press blade stop lever (1) to the
handlebar and hold.
2 Pull blade clutch lever (2) back to
the stop and allow to engage.
Keep blade stop lever (1) pressed when
working.
Risk of injury!
For safety reasons, the lever must
never be disabled, e.g. by tying it to
the handlebar.
Operation of the blade brake clutch
must be checked before each use.
(Ö 10.4)
Avoid damage to the machine!
Avoid overloading as this can result
in greater wear to the blade brake
clutch and consequently to
overheating. (Ö 9.)
9. Notes on working with the
machine
10. Operating the machine
Risk of injury!
Carefully read and observe the “For
your safety” section before
operating the machine. (Ö 4.)
11
Risk of injury!
If the recoil starter rope recoils at
high speed, the hand and arm will
be pulled towards the engine faster
than the cable can be released.
This can result in broken bones,
crush injuries and sprains.
Avoid damage to the machine!
Do not engage the mowing blade in
tall grass and only engage it at the
maximum engine speed.
Always engage it quickly in order to
prevent unnecessary wear to the
blade clutch.
12
45

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Viking MB 756 YS bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Viking MB 756 YS in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Pools als bijlage per email.

De handleiding is 13,31 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info